EasyManua.ls Logo

Schumacher SE-2001 - User Manual

Schumacher SE-2001
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1
A. GENERAL BATTERY SAFETY
1. Before you use your battery charger, be sure to read all
instructions and cautions printed on:
• Battery Charger
• Battery
• Vehicle or unit using battery
2. Use battery charger on LEAD ACID type rechargeable bat-
teries only, such as used in autos, trucks, tractors, airplanes,
vans, RV's, trolling motors, etc. Charger is not intended to
supply power to low-voltage electrical system other than in
an automotive application.
WARNING: Do not use battery charger for charging dry-
cell batteries that are commonly used with home appliances.
These batteries may burst and cause injury to persons and
damage to property.
3. Use only attachments recommended or sold by manufac-
turer. Use of non-recommended attachments may result in
fire, electric shock, or injury.
4. When disconnecting the battery charger, pull by the plug
not by the cord. Pulling on the cord may cause damage to
cord or plug.
5. Locate battery power cord so it cannot be stepped on, tripped
over, or subjected to damage or stress.
6. Do not operate charger with damaged cord or plug. Have
cord replaced immediately.
7. Do not operate charger if it has received a sharp blow, been
dropped, or otherwise damaged in any way. Take it to a
qualified professional for inspection and repair.
8. Do not disassemble charger. Take it to a qualified profes-
sional when service or repair is required. Incorrect reas-
sembly may result in electric shock or fire.
9. To reduce risk of electric shock, unplug charger from outlet
before attempting any maintenance or cleaning.
10. Do not use an extension cord unless absolutely necessary.
Use of an improper extension cord could result in fire or
electric shock. If an extension cord must be used, make
sure that:
• Pins on plug of extension cord are the same number, size,
and shape as those of the plug on the charger.
• Extension cord is properly wired and in good electrical
condition.
• Wire size is large enough for AC ampere rating of charger,
as specified below:
_____________________________________________
Length of cord (feet): 25 50 100 150
AWG size of cord: 16 12 10 8
(American Wire Gauge)
_____________________________________________
11. Always charge battery in a well ventilated area.
NEVER operate in a closed-in or restricted area without
adequate ventilation because of risk of explosive gases.
WARNING: Risk of explosive gas.
12. Locate charger as far away from battery as DC charger
cables permit.
13. Do not expose charger to rain or snow.
14. NEVER charge a frozen battery. If battery fluid (electrolyte)
is frozen, bring into a warm area to thaw before charging.
15. NEVER allow battery acid to drip on charger when reading
specific gravity or filling battery.
16. NEVER set a battery on top of charger.
17. NEVER place charger directly above battery being charged.
Gases from battery will corrode and damage charger.
18. NEVER touch the battery clips together when the charger is
energized.
Read Rules for Safe Operation and Instructions Carefully
Working in vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during normal
battery operation. For this reason, it is of utmost importance that each time before using your charger, you
read this manual and follow the instructions exactly.
Owner's Manual
–Save–
Important Safety Instructions
WARNING: Handling the cord on this product or cords associated with accessories sold with this product, will expose you to lead, a
chemical known to the State of California to cause cancer and birth defects or other reproductive harm.
Wash hands after handling.
SE-2001, SE-4020, SE-4022
SE-6030, SE-8050
Battery
Charger
Models:
00-00-000484/0103
SCHUMACHER ELECTRIC CORPORATION
801 BUSINESS CENTER DRIVE • MOUNT PROSPECT, ILLINOIS 60056-2179
Send Warranty Product Repairs to: 1025 E. Thompson, Hoopeston, IL 60942-0280
Call Customer Service if you have questions: 1-800-621-5485

Questions and Answers

  • D
    dsanfordJul 30, 2025
    Why is my Schumacher SE-2001 clicking?
    • J
      Jeffrey MccallJul 30, 2025
      A clicking noise from your Schumacher Battery Charger can be due to several reasons. The circuit breaker might be cycling, the battery could be defective, or it may be severely discharged but otherwise in good condition. It could also be due to reverse connections at the battery. Ensure the switch is in the correct position. Have the battery checked. If the battery is severely discharged, allow charging to continue until it recovers sufficiently, but if clicking persists for more than 20 minutes, stop charging and have the battery checked. If the lead connections are reversed, shut off the charger and correct them.
  • S
    Stephanie WrightAug 9, 2025
    What to do if my Schumacher SE-2001 won't turn on?
    • B
      Benjamin SchneiderAug 9, 2025
      If your Schumacher Battery Charger doesn't turn on when properly connected, it could be due to a dead AC outlet or a poor electrical connection. To resolve this, plug in a lamp to the AC outlet to check for voltage. Also, check the connections and rock them back and forth to ensure a better electrical connection.
  • C
    Cheryl LewisAug 19, 2025
    How to fix no meter reading on Schumacher SE-2001 Battery Charger?
    • M
      Mark MartinezAug 19, 2025
      If there is no meter reading on your Schumacher Battery Charger, and the AC cord is unplugged, it may be because the clips are not making a good connection, the battery voltage is too low, or a 2 amp charge rate is being used. Try rocking the clips back and forth for a better connection. Also, ensure the AC line is plugged into an outlet, which should then make the meter indicate.

Summary

General Battery Safety

Personal Precautions and Safety

Ground and AC Power Cord Connections

Preparing to Charge

Charger Location Precautions

Operating Instructions: Charging Battery in Vehicle

Operating Instructions: Charging Battery Out of Vehicle

Output Selector Controls

Engine Start

Charge Period

Battery Charging

Assembly Instructions

Wheel Charger Assembly Instructions

Instructions for assembling the wheel charger unit before operation.

Troubleshooting

Schumacher SE-2001 Specifications

General IconGeneral
Input Voltage120V AC
Output Voltage6V / 12V
Output Current2A
Input Frequency60Hz
Battery TypeLead Acid
Cable Length6 feet

Related product manuals