EasyManua.ls Logo

Schumacher SE-1275A - User Manual

Schumacher SE-1275A
12 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1
00-00-000579/0103
IMPORTANT SAFETY INSTRUCTIONS
A.
1. SAVE THESE INSTRUCTIONS - This manual contains
important safety and operating instructions for battery
charger Models: SE-520MA, SE-5212A and SE-1275A.
A BATTERY CHARGER RECEIVES AC POWER FROM
THE ELECTRIC OUTLET AND DELIVERS DC CUR-
RENT TO THE BATTERY.
2. Before using battery charger, read all instructions and
cautionary markings on (1 ) battery charger, (2) battery
and (3) product using battery.
3. CAUTION - To reduce risk of injury, charge only lead
acid type rechargeable batteries: Other types of batter-
ies may burst causing personal injury and damage.
4. Do not expose to rain or snow.
5. Use of an attachment not recommended or sold by the
battery charger manufacturer may result in a risk of fire,
electric shock, or injury to persons.
6. To reduce risk of damage to electric plug and cord, pull
by plug rather than cord when disconnecting charger.
7. Make sure cord is located so that it will not be stepped
on, tripped over, or otherwise subjected to damage or
stress.
8. An extension cord should not be used unless absolutely
necessary. Use of improper extension cord could result
in a risk of fire and electric shock. If extension cord must
be used, make sure:
(a) That pins on plug of extension cord are the same
number, size and shape as those of plug on charger;
(b) That extension cord is properly wired and in good
electrical condition;and
(c) That wire size is large enough for AC ampere rating of
charger as specified below:
AC INPUT RATING, AMPERES AWG SIZE OF CORD
Equal to or but less than Length of Cord, Feet
Greater than 25 50 100 150
0 2 18 18 18 16
2 3 18 18 18 14
6 8 18 16 12 10
9. Do not operate charger with damaged cord or plug -
replace it immediately.
10. Do not operate charger if it has received a sharp blow,
been dropped or otherwise damaged in any way; take it
to a qualified serviceman.
11. Do not disassemble charger; take it to a qualified
serviceman when service or repair is required. Incorrect
reassembly may result in a risk of electric shock or fire.
12. To reduce risk of electric shock, unplug charger from
outlet before attempting any maintenance or cleaning.
Turning off controls will not reduce this risk.
Read Rules for Safe Operation and Instructions Carefully
Working in vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during normal
battery operation. For this reason, it is of utmost importance that each time before using your charger, you
read this manual and follow the instructions exactly.
Owner's Manual
–Save–
Important Safety Instructions
WARNING: Handling the cord on this product or cords associated with accessories sold with this product, will expose you to lead, a
chemical known to the State of California to cause cancer and birth defects or other reproductive harm.
Wash hands after handling.
SE-520MA 2/10 Amp 12 Volt
SE-5212A 2/10/50 Amp 12 Volt
SE-1275A 2/12/75 Amp 12 Volt
Battery
Charger
Models:
SCHUMACHER ELECTRIC CORPORATION
801 BUSINESS CENTER DRIVE • MOUNT PROSPECT, ILLINOIS 60056-2179
Send Warranty Product Repairs to: 1025 E. Thompson, Hoopeston, IL 60942-0280
Call Customer Service if you have questions: 1-800-621-5485

Table of Contents

Questions and Answers

  • M
    matthewyatesJul 30, 2025
    Why won't my Schumacher Battery Charger turn off?
    • A
      Andrew SotoJul 30, 2025
      If your Schumacher Battery Charger will not turn OFF, the battery may have a problem and is not taking a full charge. In this case, have the battery checked.
  • L
    Logan LeeAug 6, 2025
    What to do if Schumacher SE-1275A Battery Charger will not turn ON?
    • H
      Helen SparksAug 6, 2025
      If your Schumacher Battery Charger does not turn on when properly connected to power, it is possible that the battery does not need charging because it was recently used in a vehicle and is fully charged. If the battery is in the vehicle, turning on the headlights will lower the battery voltage in a few seconds, and the charger should then turn on.
  • L
    lauraramirezAug 11, 2025
    What to do if Schumacher SE-1275A meter needle swings and clicks?
    • M
      Michael CarrAug 11, 2025
      If the meter needle on your Schumacher Battery Charger moves to the extreme right, stays there briefly, returns to zero, and you hear a clicking sound, it could be due to several reasons. The battery might be severely discharged but otherwise in good condition, defective and unable to accept a charge, or the charger is cycling after a circuit breaking overload. Let the charging continue, so the battery recovers enough to take a charge. The circuit breaker will continue to cycle, and the needle will swing side to side until the battery recovers. Also, have the battery checked. Wait for the charger to automatically reset itself.
  • L
    Lindsey FrazierAug 17, 2025
    How to fix a Schumacher SE-1275A Battery Charger with no meter reading?
    • M
      Michael DunnAug 17, 2025
      If your Schumacher Battery Charger shows no meter reading, there might be a few reasons: * The connections could be reversed, or there might be a poor electrical connection. Disconnect the charger, reverse the clips, and reconnect them, rocking them back and forth to ensure a good connection. Clean the clips and battery posts before reconnecting. * The AC outlet might not be working. Plug in a lamp or another appliance to check if the outlet has voltage. * The battery might be defective and unable to accept a charge. Have the battery checked.
  • C
    Cassandra GutierrezAug 23, 2025
    Why does the Schumacher Battery Charger needle pulse after hours?
    • D
      davisanneAug 23, 2025
      If the meter needle on your Schumacher Battery Charger pulses or fluctuates every few seconds AFTER THREE HOURS without slowing down, it could be due to a few reasons: * Two or more batteries are connected in parallel. * The battery is a large 200 ampere hours or larger. * The battery is connected to an application that draws a small current, such as an autodome light. Do not parallel charge. Because it requires more time to charge, continue charging.

Summary

IMPORTANT SAFETY INSTRUCTIONS

General Safety and Handling

Read all instructions, handle battery types properly, avoid environmental hazards, and maintain charger safely.

WARNING - RISK OF EXPLOSIVE GASES

Explosive Gas Hazards

Batteries generate explosive gases; follow instructions to mitigate explosion risks.

PERSONAL PRECAUTIONS

PREPARING TO CHARGE

BATTERY CHARGER CONTROLS

SE-1275-A Operation Modes

Select battery type and charge rate (2A, 12A, 75A Engine Start) using switches.

SE-5212-A Operation Modes

Select battery type and charge rate (2A, 10A, 50A Engine Start) using switches.

METER READINGS AND CONNECTIONS

DC Connection Precautions

Proper clip connection sequence, terminal connection technique.

BATTERY INSTALLATION IN VEHICLE

OUTSIDE VEHICLE AND POWER CONNECTIONS

AC Power Cord Safety and Requirements

Do not alter cord/plug; use qualified electrician; charger is for 120V/60Hz.

TROUBLESHOOTING

Troubleshooting Common Issues

Schumacher SE-1275A Specifications

General IconGeneral
Input Voltage120V AC
Input Frequency60 Hz
Output Voltage12V DC
Automatic Shut-OffYes
Reverse Hook-Up ProtectionYes
Charging ModesManual, Automatic
Battery TypeAGM, Gel
Cable Length6 ft

Related product manuals