EasyManua.ls Logo

Schumacher Elite SE-1555A - User Manual

Schumacher Elite SE-1555A
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1
A. GENERAL BATTERY SAFETY
1. Before you use your battery charger, be sure to read all
instructions and cautions printed on:
Battery Charger
Battery
Vehicle or device using battery
2. Use battery charger on LEAD ACID type rechargeable
batteries only, such as used in autos, trucks, tractors, airplanes,
vans, RVs, trolling motors, etc. Charger is not intended to
supply power to low-voltage electrical system other than in
an automotive application.
WARNING: Do not use battery charger for charging dry-cell
batteries that are commonly used with home appliances. These
batteries may burst and cause injury to persons and damage
to property.
3. Use only attachments recommended or sold by manufacturer.
Use of non-recommended attachments may result in re,
electric shock, or injury.
4. When disconnecting the battery charger, pull by the plug not
by the cord. Pulling on the cord may cause damage to cord or
plug.
5. Locate battery power cord so it cannot be stepped on, tripped
over, or subjected to damage or stress.
6. Do not operate charger with damaged cord or plug. Have cord
replaced immediately.
7. Do not operate charger if it has received a sharp blow, been
dropped, or otherwise damaged in any way. Take it to a
qualied professional for inspection and repair.
8. Do not disassemble charger. Take it to a qualied professional
when service or repair is required. Incorrect reassembly may
result in electric shock or re.
9. To reduce risk of electric shock, unplug charger from outlet
before attempting any maintenance or cleaning.
10. Do not use an extension cord unless absolutely necessary.
Use of an improper extension cord could result in re or electric
shock. If an extension cord must be used, make sure that:
Pins on plug of extension cord are the same number, size,
and shape as those of the plug on the charger.
Extension cord is properly wired and in good electrical
condition.
Wire size is large enough for AC ampere rating of charger,
as specied below:
Length of cord (feet): 25 50 100 150
AWG size of cord: 16 14 10 8
(American Wire Gauge)
11. Always charge battery in a well ventilated area.
NEVER operate in a closed-in or restricted area without
adequate ventilation because of risk of explosive gases.
WARNING: Risk of explosive gas.
12. Locate charger as far away from battery as DC charger cables
permit.
13. Do not expose charger to rain or snow.
14. NEVER charge a frozen battery. If battery uid (electrolyte) is
frozen, bring into a warm area to thaw before charging.
15. NEVER allow battery acid to drip on charger when reading
specic gravity or lling battery.
16. NEVER set a battery on top of charger.
17. NEVER place charger directly above battery being charged.
Gases from battery will corrode and damage charger.
18. NEVER touch the battery clips together when the charger is
energized.
00-99-000810/0607
SCHUMACHER ELECTRIC CORPORATION
801 BUSINESS CENTER DRIVE • MOUNT PROSPECT, ILLINOIS 60056-2179
In United States: Send Warranty Product Repairs to: 1025 E. Thompson, Hoopeston, IL 60942-0280
Call Customer Service if you have questions: 1-800-621-5485
Read Rules for Safe Operation and Instructions Carefully
Working in vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during normal battery
operation. For this reason, it is of utmost importance that each time before using your charger, you read this manual
and follow the instructions exactly.
Owner's Manual
Save
Important Safety Instructions
WARNING: Handling the cord on this product or cords associated with accessories sold with this product, may expose you to lead, a
chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.
Battery
Charger
Model:
SE-1555A
Automatic/Manual Battery Charger
2 Amp, 12 Volt
20 Amp, 12 Volt
55 Amp, 12 Volt
150 Amp, 12 Volt, Engine Start

Questions and Answers

  • T
    Thomas GuerreroJul 25, 2025
    What to do if the Schumacher Battery Charger circuit breaker cycles on and off?
    • C
      Carolyn JosephJul 26, 2025
      If the Schumacher Battery Charger circuit breaker cycles on and off accompanied by a clicking sound, it indicates the current draw is too high. Ensure that the battery clamps are separated and inspect cables for wear, replacing them if necessary. Verify that the connections are correctly made and that the Volt/Amp Selector setting is appropriate for your battery type.
  • R
    Ralph RobertsJul 30, 2025
    What to do if there is no reading on the Schumacher Battery Charger display and the fan is not working?
    • E
      Erin CruzJul 30, 2025
      If there is no reading on the Schumacher Battery Charger's digital display, and the charger fan isn't working, start by checking the AC outlet and any extension cords for loose plugs. Also, check the AC outlet for an open fuse or tripped circuit breaker. Finally, make sure the charger switch is in the ON position.
  • P
    Paul MartinezAug 3, 2025
    Why does my Schumacher Battery Charger display read less than selected charge rate?
    • S
      Samuel SmithAug 3, 2025
      If the Schumacher Battery Charger's digital display reads less than the selected charge rate when charging a discharged battery, it could be due to several reasons. Try using a shorter or heavier gauge extension cord. It's also possible that the battery has a weak cell or sulfated plate; a sulfated battery may eventually accept a normal charge over time. If the battery still won't charge, have it tested by a qualified technician. You can also continue to charge the battery.
  • E
    Eric UnderwoodAug 7, 2025
    What to do if the Schumacher Battery Charger digital display shows no reading?
    • A
      Allison BakerAug 8, 2025
      If the Schumacher Battery Charger's digital display shows no reading or doesn't change, it could be due to a severely discharged battery. In this case, continue charging the battery for an additional two hours. Also, verify that the SELECT DISPLAY MODE and SELECT VOLT/CHARGE RATE options are correctly selected.
  • A
    Antonio MillerAug 12, 2025
    How to fix no reading on amps digital display of Schumacher Battery Charger?
    • A
      Alicia HowardAug 12, 2025
      If the Schumacher Battery Charger shows no reading on the amps digital display, ensure the clips are making a solid connection. Check for poor connections at the battery and ensure the clamps and posts are clean. If the battery is excessively run down, it may not accept a charge. Note that the digital display may not show activity at the 2 amp setting.
  • G
    Gregory ShawAug 16, 2025
    Why is there a short start cycle when cranking the engine using Schumacher Battery Charger?
    • W
      William PattersonAug 16, 2025
      If you experience a short start cycle when cranking the engine with the Schumacher Battery Charger, it could be because you are drawing more than 150 amps for 3 seconds or less. Also, you should wait 3 minutes (180 seconds) between cranking attempts. If cranking draws more than 150 amps, crank time may be less than 3 seconds. Always allow a 3-minute wait before attempting the next crank.
  • A
    Allen MyersAug 20, 2025
    Why does my Schumacher Elite SE-1555A make a loud buzzing or humming noise?
    • J
      Jennifer MuellerAug 20, 2025
      If the Schumacher Battery Charger makes a loud buzzing or humming noise, it is likely due to the transformer laminations vibrating. This is not an abnormal occurrence, so you can continue charging.

Summary

Important Safety Instructions

General Battery Safety

Read all instructions and cautions for safe battery charger and vehicle operation.

Personal Safety Precautions

Wear protective gear and take precautions to avoid acid and sparks.

Plugging In and Grounding

Ensure proper outlet connection and grounding for electrical safety.

Preparing to Charge Battery

Follow guidelines for battery type, terminal cleaning, and ventilation.

Operating Instructions

Charging Battery in Vehicle

Steps for safely charging a battery while it remains installed in the vehicle.

Charging Battery Out of Vehicle

Procedure for safely removing and charging a battery outside the vehicle.

Controls and Features

Output Selector Controls

Understanding digital display, timer, and selection buttons for operation.

Battery Testing and Alternator Display

How to test battery voltage and check vehicle alternator performance.

Charge Rate Selection

Guidance on selecting appropriate charge rates for different battery types.

Charging Procedures

Charge Period Calculation

Methods to determine charge time using hydrometer or electronic testers.

Battery Charging Assembly

Steps for assembling the charger before initial use.

Assembly, Maintenance, and Care

Assembly Instructions

Detailed steps for assembling the charger unit with provided parts.

Maintenance and Care

Guidelines for cleaning and maintaining the charger for longevity.

Troubleshooting

Problem Diagnosis and Solutions

Common issues, their causes, and recommended solutions for charger operation.

Schumacher Elite SE-1555A Specifications

General IconGeneral
BrandSchumacher
ModelElite SE-1555A
CategoryBattery Charger
LanguageEnglish

Related product manuals