Need help?Do you have a question about the Schumacher SL886RU and is the answer not in the manual?
General| Brand | Schumacher |
|---|---|
| Model | SL886RU |
| Category | Work Light |
| Language | English |
Manual contains important safety and operating instructions.
Read and follow all instructions, cautions, and warnings for safety.
Charge the work light immediately after purchase, after each use, and every 6 months.
Do not operate the work light while it is being charged.
Do not handle or move the work light while charging.
Do not cover or block the light lens during use.
Avoid looking directly into the light or shining it into eyes.
Do not allow children to use the work light.
Operate the work light only on flat, stable surfaces.
Do not operate if damaged; seek qualified service.
Do not leave the battery in a discharged state.
Use a USB charging port rated for 1A @ 5V DC or higher.
Do not use a charger with a damaged cord or plug.
Do not immerse the work light in water.
Unplug and cool the light before cleaning.
Do not disassemble; seek qualified service for repair.
Do not crush, puncture, short, or dispose of in fire/water.
Do not expose to temperatures above 113°F (45°C).
Recycle or dispose of the used battery according to local regulations.
If electrolyte contacts skin/eyes, wash immediately and seek medical attention.
Firefighting instructions for lithium-ion battery, including cooling precautions.
Remove cord wraps and uncoil the charging cable before use.
Charge the work light immediately after purchase, after each use, and every 6 months.
Ensure the work light is turned off before initiating charging.
Insert the micro USB end into the light and the USB end into the charger.
Plug your charger into a live power source.
Red LED blinks during charging; turns green when fully charged.
Charging takes approximately 4 hours; do not exceed 24 hours.
Unplug the unit from the charger once fully charged.
Recharge the work light after use and at least every 6 months.
Charge the internal battery before use, ensuring the light is powered off.
Hang using the hook and press the front button to open/rotate for positioning.
Attach the magnetic end of the work light to any ferrous metal surface.
Direct the lens away from your eyes before turning the light on.
Press the Power Level button for low or high power settings.
Press the Power Level button to turn the unit off when finished.
Recharge the work light after use and at least every 6 months.
Unplug and disconnect the work light before performing maintenance.
Allow the work light to cool before attempting any cleaning.
Use a dry cloth to wipe any dirt or oil from the charging cable and case.
Any servicing should be performed by qualified service personnel.
Store inside, in a cool, dry place.
Take care to avoid/prevent damage to the charging cable and unit.
Charge the work light's internal battery after purchase, after every use and every 6 months.
Ideal storage is 70°F (21°C); avoid warm environments to prevent battery damage.
Problem: Light does not operate. Cause: Battery not charged. Solution: Recharge battery.
Do not ship unit until you receive a RETURN MERCHANDISE AUTHORIZATION (RMA) number.
Ship via insured ground service with tracking; customer responsible for return shipping charges.
Do not dispose with household waste; recycle responsibly.
Use return/collection systems or contact retailer for environmentally-safe recycling.
Lithium Ion 18650, 3.7V, 2600 mAh.
High power: 600 lm; low power: 300 lm.
6W COB.
High power: 1.5 hours; low power: 3 hours.
4 hours.
Part number: 3899003983Z.
SA3280 charging kit (110V wall charger and 12V DC charger). Part number: 2299003280Z.
To Next Page
