Need help?Do you have a question about the Schwinn active 10 Series and is the answer not in the manual?
General| Brand | Schwinn |
|---|---|
| Model | active 10 Series |
| Category | Exercise Bike |
| Language | English |
Secure Front Stabilizer (2) and Rear Stabilizer (3) to Main Body (1) using bolts, washers, and nuts.
Assemble the Front Roller facing forward, positioning the Front Stabilizer with the arrow pointing upwards.
Connect the Console Mast Wire (20) to the Main Frame Wire (21).
Attach the Console Mast (4) to the Main Body (1) using Arc Washers (19) and Hex Screws (18).
Connect Console Mast Wire (20) to Console Wire (23) and route wires through the Console Mast (4).
Side the Console Assembly (6) onto the Console Mast (4) and secure with four Phillips Screws (14).
Secure the Handlebar (5) to the Console Mast (4) using C-ring (30), Flat Hex Screw (27), and Adjustment Knob (26).
Connect the Heart Rate Wire (24) to the female connector from the Console (6).
Side Seat Post Cover (13) over Seat Post (7) and insert Seat Post into Main Body (1) with Quick Release Knob (11).
Install Seat Pad (8) on Seat Post (7) and tighten the nut underneath to secure the seat.
Install the Left Pedal (9) to Left Crank (25) and Right Pedal (10) to the Right Crank.
Insert C batteries into the back of the console as indicated in the battery bay.
Inspect the machine to ensure all fasteners are tight and components are properly assembled. Review warnings.
To Next Page
