Need help?Do you have a question about the Schwinn AC Performance and is the answer not in the manual?
General| Frame Material | Aluminum |
|---|---|
| Resistance System | Magnetic |
| Maximum User Weight | 350 lbs (159 kg) |
| Bike Type | Indoor Cycling Bike |
| Weight | 112 lbs (51 kg) |
| Drive System | Belt |
| Pedals | SPD and Toe Clip |
| Display Type | LCD |
| Heart Rate Monitoring | Yes |
| Seat Adjustment | Fore/Aft and Up/Down |
Install front and rear stabilizers using specified tools and hardware.
Insert and secure seat post slider with locking nuts using a 10mm allen key.
Attach fore/aft adjustment knob and secure seat post end cap with M4 screw.
Install handlebar post slider and secure with locking nut using a 10mm allen key.
Attach handlebar fore/aft adjustment knob and secure handlebar post end cap with M4 screw.
Slide seat post assembly into frame by loosening height adjustment pop pin.
Slide handlebar post assembly into frame by loosening height adjustment pop pin.
Install left crank arm onto bottom bracket, torquing to 33-37 ft-lbs (48 Nm).
Install pedals into crank arms, torquing to 33-37 ft-lbs (48 Nm) for proper function.
Install front and rear stabilizers using specified tools and hardware (M8 x 45mm screws).
Tighten seat post fore/aft adjustment pin and slide seat slider onto the seat post.
Loosen seat post height adjustment pin and slide seat post assembly into the frame.
Tighten handlebar fore/aft adjustment pin and secure handlebars with M5 screw.
Loosen handlebar post height adjustment pin and slide handlebar post assembly into the frame.
Install left crank arm onto bottom bracket, torquing to 33-37 ft-lbs (48 Nm).
Install pedals into crank arms, torquing to 33-37 ft-lbs (48 Nm) for proper function.
To Next Page