Schwinn Crewmaster - Page 33

33
Note: Your machine may not match the image. For reference only.
1. Carefully remove the screws (indicated) that attach the Shrouds to the
frame.Removethebottomscrewsrst.Setthehardwaresafelyaside.
2. Remove the Shrouds and set them safely aside.
NOTICE: Do not crimp the cables.
3.Installationisthereverseprocedure.Installthetopscrewsrst.
NOTICE: Do not crimp the cables.
4. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.