35
Note: Your machine may not match the image. For reference only.
1. Place a static object (like a book or box) under the front Stabilizer. The
static object should not be compressible.
2. Remove the 2 screws and footpad from the bottom of the Endcap. Set
them safely aside.
3. Slide the Endcap off the end of the Stabilizer.
4. Attach the footpad to the Endcap. Do not fully tighten the screws.
5. Slide the Endcap onto the Stabilizer. Fully tighten the screws.
6. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.
To Next Page
Loading...
