SciCan STATIM 2000/S - Statim Rev. 7 PCB User and Service Menus; User Setup Menu; Service Menu

To Next Page

To Previous Page

8. Statim Rev. 7 PCB User and Service Menus

1. User setup menu ........................................................................................................... 16

1.1 Time/Date Setup Mode........................................................................................... 16

1.2 Language Setup ..................................................................................................... 17

1.3 Unit ID Setup .......................................................................................................... 17

1.4 Water Quality.......................................................................................................... 18

1.5 Last Printout ........................................................................................................... 18

1.6 RS232 .................................................................................................................... 18

1.7 End of Line CR/LF .................................................................................................. 19

1.8 Serial Port Bit Rate ................................................................................................. 20

1.9 Printer user ° char................................................................................................... 20

1.10 Save and Exit ......................................................................................................... 20

1.11 Exit ......................................................................................................................... 20

2. Service Menu................................................................................................................. 21

2.1. Calibration .............................................................................................................. 22

2.2. Set cycle counter .................................................................................................... 24

2.3. Lock cycles............................................................................................................. 24

2.4. Conductivity Setup.................................................................................................. 25

2.5. Water.Cnd Tmp. Comp........................................................................................... 26

2.6. Stored CF Printouts ................................................................................................ 26

2.7. Clear CF Printouts .................................................................................................. 26

2.8. Display last CF# ..................................................................................................... 27

2.9. Devices Test On/Off ............................................................................................... 27

2.10. Temperature Offset ............................................................................................. 27

2.11. Press. Atm. Offset ............................................................................................... 28

2.12. Press. Ster. Offset............................................................................................... 28

2.13. Press. Sensor Type............................................................................................. 28

2.14. Validation Offset.................................................................................................. 29

2.15. Voltage Calibration.............................................................................................. 29

2.16. Voltage setup ...................................................................................................... 29

2.17. Repeater mode ................................................................................................... 30

2.18. Factory default .................................................................................................... 30

2.19. Change Password............................................................................................... 30

2.20. Backup NVRAM .................................................................................................. 31

2.21. Restore NVRAM.................................................................................................. 31