What to do if my SciGene Hybex Accessories instrument does not turn on?
If your SciGene Accessories instrument doesn't turn on, the issue might be due to a lack of power or a blown fuse. First, check the power source and ensure the power cord is properly connected. If that doesn't solve the problem, replace the fuse located beneath the power cord on the back of the unit.
General| Brand | SciGene |
|---|---|
| Model | Hybex |
| Category | Accessories |
| Language | English |
Defines the primary purpose of the Hybex Microsample Incubator.
Information regarding hazards and safe operation practices for the instrument.
Explains electrical symbols used on the instrument for safety awareness.
Explains non-electrical symbols, including electrical and heat hazards.
Details warnings about potential personal injury or death from non-compliance.
Lists cautionary statements about potential personal injury from non-compliance.
Outlines compliance with CE, WEEE, RoHS, and laboratory equipment standards.
Indicates compliance with EU directives for EMC and Low Voltage.
Explains WEEE directive and proper disposal of electronic equipment.
Details RoHS directive restricting hazardous materials in electronic equipment.
States the instrument meets specific UL and CSA standards.
Declares Class A digital device status under FCC and EN standards.
Instructions for removing the unit from packaging and inspecting for damage.
Lists the components included with the Hybex heating base.
Specifies ambient temperature, humidity, and airflow clearance needed for operation.
Guides on placing the unit, ensuring clearance, and connecting the power cord.
Identifies and describes the functions of the instrument's components and accessories.
Provides instructions on how to install and remove heating blocks and waterbath inserts.
Explains how to set and adjust the desired temperature using the controller.
Instructions for safely turning off the instrument before performing maintenance.
Guidelines for cleaning the instrument's surfaces using appropriate cleaning agents.
Details how to check and replace the unit's fuses for continued operation.
Explains how to set the desired temperature using the Watlow SD31 controller.
Provides steps for re-calibrating the controller for accurate temperature readings.
To Next Page