Scope Communications UK Ltd
Ref: 40A7PROGMANUAL Page 9 of 11 Issue 1
31) [Time Display]
When Tick box is left blank, the time display (normally visible when
pager is in standby mode) is inhibited.
32) [Unread Message Indication]
When Tick box is left blank, the unread message indicator is
inhibited.
33) [Message Status]
When Tick box is checked, displays the message number and call
type. This can either be pre-fixed or suffixed to the message using
the “prefix” tick box.
34) [Time Stamp]
When Tick box is checked, messages will be time stamped. This
can either be pre-fixed or suffixed to the message using the “prefix”
tick box. Note that Time Display must be enabled.
35) [Hand Program]
When Tick box is checked, allows user to hand program the
frequency, capcodes and baud rate settings.
36) [Auto Spacing]
When Tick box is checked, messages are auto spaced (word
wrapped) on the display, to prevent part-words from being shown.
37) [Message Lock Menu]
When Tick box is checked, messages can be locked to prevent
accidental erasure.
To Next Page
Loading...
