Scope Communications UK Ltd
Ref: 40A7PROGMANUAL Page 10 of 11 Issue 1
38) [Message Full Warning]
When Tick box is checked, a “Message Full” warning will be shown
on the display when the maximum number of messages has been
reached.
39) [Low bat special alert]
When Tick box is checked, to indicate low battery condition the
pager will vibrate pattern B for 3 seconds every 15 minutes until the
battery is changed. The low battery icon will also be shown on the
display continuously until battery is replaced.
40) [Out of range special display]
For use only with a Scope supervised transmitter system. When
pager goes out of range, display will show “No Service” and vibrate
continuously until reset by the user (pressing any button). A three
second reminder vibrate alert will be sent every 15 minutes until the
pager comes back into range.
41) [Alarm Function]
When Tick box is checked, alarm clock function is enabled. Note:
time display must also be enabled for this feature to operate.
42) [Auto On/Off Enable]
When Tick box is checked, Auto On/Off function is enabled. See
also item 25 above.
43) [Canned Message]
When Tick box is checked, up to four preset messages of up to
twenty characters in length can be entered. These are displayed by
sending a tone only A, B, C or D call.
To Next Page
Loading...
