SCORPION EXO-AT950 - Front View of the Helmet; Removing the Neck Roll

3
4
DO NOT ATTEMPT TO ADJUST WHILE RIDING
Aero-Tuned Peak Visor
Speedview
®
Sunvisor
Retraction-lever
Speedview
®
Internal Sunvisor
Faceshield
Lift/lock tab
Mouth Intake Vent
Single button Face Bar
release
Crown Liner
Neck Roll and Cheek Pad
(Exterior View)
Neck Roll and Cheek Pad
(Side View)
!WARNING! Always check to make sure the crown liner, neckroll and cheek pad are installed before using the
helmet. A helmet without the crown liner and/or cheekpad may increase your risk of serious injury or death.
USING THE RETRACTABLE
SPEEDVIEW® SUNVISOR
NOTE: THE RETRACTABLE INTERNAL SUNVISOR CAN
BE LOWERED AND RETRACTED, REGARDLESS OF
WHETHER OR NOT THE FACESHIELD IS UP OR DOWN.
To raise the sunvisor, just
slide the SpeedView
®
Sunvisor
Retraction-lever towards the front
of the helmet.
To lower the sunvisor, simply
slide the SpeedView
®
Sunvisor
Retraction-lever towards the back
of the helmet.
REMOVING THE NECK ROLL
and attached CHEEKPADS
Gently pull cheek pads away from the interior wall of helmet to
unsnap the three plastic clips on each side. Next, gently tug away the
Neck Roll with attached cheek pads away from helmet.
FRONT VIEW OF THE HELMET
3
4
DO NOT ATTEMPT TO ADJUST WHILE RIDING
Aero-Tuned Peak Visor
Speedview
®
Sunvisor
Retraction-lever
Speedview
®
Internal Sunvisor
Faceshield
Lift/lock tab
Mouth Intake Vent
Single button Face Bar
release
Crown Liner
Neck Roll and Cheek Pad
(Exterior View)
Neck Roll and Cheek Pad
(Side View)
!WARNING! Always check to make sure the crown liner, neckroll and cheek pad are installed before using the
helmet. A helmet without the crown liner and/or cheekpad may increase your risk of serious injury or death.
USING THE RETRACTABLE
SPEEDVIEW® SUNVISOR
NOTE: THE RETRACTABLE INTERNAL SUNVISOR CAN
BE LOWERED AND RETRACTED, REGARDLESS OF
WHETHER OR NOT THE FACESHIELD IS UP OR DOWN.
To raise the sunvisor, just
slide the SpeedView
®
Sunvisor
Retraction-lever towards the front
of the helmet.
To lower the sunvisor, simply
slide the SpeedView
®
Sunvisor
Retraction-lever towards the back
of the helmet.
REMOVING THE NECK ROLL
and attached CHEEKPADS
Gently pull cheek pads away from the interior wall of helmet to
unsnap the three plastic clips on each side. Next, gently tug away the
Neck Roll with attached cheek pads away from helmet.
FRONT VIEW OF THE HELMET