7
1
2
3
4
8
OPERATION OF FLIP UP CHIN BAR
!WARNING! BE SURE THAT CHIN BAR IS CLOSED SECURELY!
DO NOT OPERATE MOTORCYCLE WITH CHIN BAR IN OPEN POSITION!
Cleaning Your Helmet System
To remove your faceshield, first you will need to remove the Peak visor.
See page 5 for detail. Once the peak visor is off. Remove the faceshield
one side at a time. Replace with new one.
Once the new faceshield is in position, re-install the Peak Visor or
optional side covers. See page 5 for details.
Continued on pg. 9
>>
FIRMLY AND SECURELY FASTEN YOUR CHINSTRAP.
Check your chinstrap for tightness occasionally as vibration or wind may
loosen it.
Do not simply pull your helmet down onto your head like a hat. Your
ScorpionExo
®
helmet should be worn as follows: Using both hands grab
the helmet’s bottom rim while holding the chin straps with your thumbs.
Then “roll” the helmet onto your head starting at the forehead. Continue
rolling the helmet on towards the back of the head until it comes to rest
with your head fully in contact with the inner lining and cheek pads.
HOW TO USE CHINSTRAP
FACESHIELD REPLACEMENT
SECURING AND WEARING
YOUR HELMET
DO NOT ATTEMPT TO ADJUST WHILE RIDING
®
PULL LEVER DOWN AND AWAY FROM FACE
To remove the peak visor (or side covers), first make sure chin bar is closed.
Then twist off each of the 2 Peak Visor screws from both sides. Gently lift off helmet.
Peak Visor Screw
To Next Page
Loading...
