9
Warning
DO NOT
For your safety, it is important that you completely read the
owner’s manual and all warning labels.
DO NOT
ride without snugly fastening your chinstrap.
DO NOT
clean your helmet with petroleum products, solvents,
benzene, thinner or cleaning agents.
DO NOT
paint over your helmet’s finish without totally protecting
and isolating the shock-absorbing liner and plastic parts.
Your warranty will otherwise be invalidated.
DO NOT
drop your helmet from any height onto a hard surface.
This could cause damage to your helmet’s finished and/or
decrease its ability to protect you.
DO NOT
place your helmet on your motorcycle’s rearview mirror:
The sharp pressure from the mirror’s edge will compress and
damage the helmet’s shock-absorbing liner.
DO NOT
place your helmet on the motorcycle’s seat or fuel tank.
It can easily roll off and hit the ground causing damage to the
helmet. It is best to place your helmet on the ground so it cannot
fall in any direction.
DO NOT
ride with a scratched faceshield. This can impair your
vision, especially at night.
DO NOT
modify any part of your helmet, e.g., drilling the shell or
cutting and pressing the shock absorbing liner. Installation of
sound systems, speakers and microphones reduces your
helmet’s ability to protect you and is not recommended.
DO NOT
use the helmet again if it has either been dropped or
involved in an accident. Replace it even if the damage is not
visible to the naked eye.
DO NOT
wear a dark or tinted faceshield (including the
retractable SpeedView
TM
Sunvisor) in dark or poor visibility
riding conditions.
DO NOT
place your headliners and cheek pads in the dryer after
washing. Allow them to air dry.
DO NOT
attempt to remove, change or replace your faceshield
while riding your motorcycle or ATV.
DO NOT
use paint which requires heat curing.
Continued from pg. 9
>>
Learn more about other motorcycle & powersports helmets on our website.
To Previous Page
Loading...
