Scosche LOC90 User Manual

~
SCOS«
I
IE"
LOC90
ADD-ON AMPLIFIER
ADAPTER
INTRODUCTION
The
LOC90
converts speaker wire (high-\eve\)
to
RCA
outputs
(low-level)
for
the purpose
of
adding a
2-channel
or mono amplifier
to
an existing factory
or
aftermarket
stereo system. The
LOC90
features
up
to
4 volt
output
and signal sensing turn-on with ability
to
drive a relay.
The
LOC90
also includes a convenient remote
mountable volume control
for precise control over
subwoofer amplifier level from
up
front
in
the
vehicle.
©2014 SCOSCHE INDUSTRIES, INC.
Sl- 300LOC90
4/14

Scosche LOC90 Specifications

General

Type	Line Output Converter
Channels	2
Output Impedance	100 Ohms
Max Output Level	9.5V RMS
Adjustable Output	Yes
Remote Turn-On	Yes
Frequency Response	20Hz-20kHz
Output Voltage	Adjustable
Signal-to-Noise Ratio	90 dB
Dimensions	3 x 2.5 x 1 inches

Summary

Product Introduction

Before Installation

Recommended Tools for Installation

List of tools required for testing, diagnosis, and wiring the LOC90 adapter.

LOC90 Overview and Components

LOC90 Wiring Instructions

LOC90 Wiring Diagram

LOC90 Wiring Color Codes

Remote Volume Control Installation

Adjusting LOC90 Output Level

LOC90 Troubleshooting Guide

Troubleshooting No Sound Issues

Steps to resolve issues when no audio output is detected from the system.

Scosche Limited Warranty