07
06
- in case the bike is damaged by a crash or accident,
please replace all damaged parts immediately at
your local SCOTT dealer. Never try to repair bent
parts, they might fail and cause an accident!
Before riding:
In the beginning the seat height should be adjusted in
that way that your child, when sitting on the saddle,
can reach the ground with both feet. When more expe-
rienced the saddle can be raised up into perfect riding
position.
IMPORTANT:
Never exceed the seatpost and stem over the marked
area. Otherwise the connection can get loosen and can
cause in worst case a crash.
Please check that your child can reach easily the handle-
bar and use brake- and shifting levers as well as the
bell.
Before every ride:
The traffic laws demand that one checks all functions
that concern safety. Check every brake when starting
to ride. Also check the function of front and rear light
and check the air pressure of the tyres.
REPLACEMENT OF DEFECTIVE
OR BENT PARTS MAINTENANCE AND CARE
In addition to the checks listed above please check your
bike regularly or if necessary, according to the following
list or contact your local SCOTT dealer to do so in
order to reach maximum safety and fun while riding.
- All bolts and nuts, especially the quick releases of
the wheels for proper fit and in case they are loose
tighten them .
- Stem and handlebar for visible damages and replace
them if necessary. Please make sure that the bolts
are tightened evenly when closing the front cap,
according to the tightening torque recommended
by the producer of the parts.
- Braking systems
- Air pressure of the tyres according to the recom-
mendation of the producer.
- Light systems and bell
- Handlebar grips to be fixed to the handlebar
- All parts of the rear suspension system including
mounting bolts
-
The front suspension fork for perfect function and
play in the bushings.
- Front and rear derailleur for perfect function and
grease them. If necessary readjust the system and
clean it.
- The play of the headset. If necessary readjust it.
- Brake and shifting cables for perfect wear and
leakage on hydraulic systems. If necessary grease
the cables.
The table of maintenance below may help you to check
your bike regularly and keep the full performance of
your bike.
Part Description OK
Saddle/seatpost Saddle tightened on seatpost
Seatpost tightened in frame
Check for minimum insertion line (min.55mm!)
Bar/stem Check for minimum insertion (min. 65mm!)
Stem tightened on fork steerer
Bar tightened on stem
Easy to reach
Brake Brake levers easy to reach
Function ok
Check wear of brake pads
Check position of the brake pads on the rim
Brake surface on rim without oil or grease
Coaster brake Function ok
Shifting parts Function ok, adjusted acc. to owner’s manual
Chain Chain tension ok
Chain lubricated
Chaincase in good condition (if existing)
Tires Profile ok
Check air pressure acc. to recommendation shown on sidewall
Wheels Spoke tension ok and equalized
Axle nuts/quick release tightened
Training wheels Check fixation screws
Pedals
Antislip surface
Tight fixed on cranks
Bearings without lose play
Bell Easy to reach
Front light Tight fixed and adjusted
Bulp ok
Reflector clean and without cracks
Dynamo Easy rolling on tire
Electrical connections ok
Light system checked
CHECKLIST
ENGLISH
DEUTSCH
FRANÇAIS
OWNER’S MANUAL 2007
To Next Page
Loading...
Need help?
General
