ENGLISHENGLISH
•
CABLE GUIDES AND CABLING
On the SCOTT Scale carbon the cable guides on the headtube can be changed if required
so different cable configurations can be used.
The main cover plate of the cable guide is available in two options:
- HT-Blank: this can be used when no cables are to be routed.
- HT: this is open and can be used for different cable options.
If cables are to be routed you must select the correct insert for the cover depending on the
configuration you require, the inserts can be easily changed in cover plate once the cables
have been removed and the cover removed from the bike.
The inserts are marked A-E, these letters dictate what cables can be used; these are the
same for left and right.
•
IMPORTANT!
For 180mm rotors, please ensure the conical washer on the front mount is fitted!
Refit the wheel and brake calliper checking the correct operation of all the components
before riding, if in any doubt please contact your SCOTT dealer for assistance and advice.
HT:
this is the cover plate
for all cable options
A:
1x Mechanical cable
D:
1x single cable & Di2
HT-Blank:
this is the no cable option
B:
2x Mechanical cables
E:
Single cable and Live valve
C:
2x mechanical cables
1x hydraulic
If you wish to change or replace the headtube cableguide set on your SCOTT Scale this kit
can be ordered from your local SCOTT dealer.
SCOTT part number: 266587 and consists of:
2x HT/A/B/C/D
1x HT-Blank/E
13 |
BIKE USER MANUAL | SCALESCALE | BIKE USER MANUAL
| 12
To Next Page
Loading...
Need help?
General
