This metal strap also helps ensure proper electrical grounding of the unit.
Ensure that you install the short part of the mounting bolt to the back of the unit and the other long part to the dashboard.
10. Reconnect the cable to the vehicle battery's negative (-) terminal. Then replace the outer trim ring and install the unit's
front panel (see the steps of 'to install the front panel').
1. Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery's negative (-) terminal.
2. Press the ( ) button to remove the front panel.
3. Lift the top of the outer trim ring then pull it out to remove it.
4. Insert both of the supplied keys into the slots at the middle left and right sides of the unit then pull the unit out of the
dashboard.
5. Remove the metal strap attached to the back of the unit (if attached).
Dismantling the unit
OPEN
GB-6
To Next Page
Loading...
