Scotts 2020-16S - Grass Catcher Assembly

ASSEMBLY
DANGER:
Do not allow any part of the power cord on the mower or
extension cord to become pinched or trapped when
assembling or raising the handles. A pinched live power cord
can cause the handles to become electrically energized.
Contact with electrically live conductive parts will result in
death by electrocution, electric shock, and/or serious personal
injury.
8
Model 2020-16S
Fig. 2
Fig. 3
To install upper handle assembly (Fig.3-4):
 Position the upper handle as shown and insert the lock
bolt through the matching holes at the bottom of the upper
handle and the top of the center handle.

Thread the upper handle lock knob onto the curved
washer and lock bolt.
 Repeat for other side.
 To secure the upper handle in place, tighten the upper
handle knobs. Avoid pinching or trapping any power cords.
 Screw the threaded nut over the thread portion of the
plug to ensure the connection is waterproof.
Fig. 4
ASSEMBLING THE GRASS CATCHER
(Fig.5):

Insert the long end of the L shaped steel tube downward
into the front catcher frame; repeat for the opposite side.
(Fig.5-1)
 Connect the short side of the L shaped steel tube with
the side catcher frame.(Fig.5-2)
 Snap the formed plastic groove over the connected
catcher frame.(Fig.5-3)
Fig. 5-1
Fig. 5-2
Fig. 5-3
To connect the power cord
 Plug the power cord extended from the upper
handle switch box tightly into the terminal
protruded from main body.