2 - 10
3/2/00
SERIAL NUMBER LOCATIONS
SPECIFICATIONS & INFORMATION
SYNTHETIC LUBRICANTS
Synthetic lubricants may be used in equipment if they
meet the applicable performance requirements
(industry classification and/or military specification) as
shown in this group.
The recommended temperature limits and service or oil
change intervals should be maintained as shown in the
operator’s manual.
Avoid mixing different brands, grades, or types of oil.
Oil manufacturers blend additive in their oils to meet
certain specifications and performance requirements.
Mixing different oils can interfere with the proper
functioning of these additives and degrade lubricant
performance.
OIL FILTERS
Filtration of oils is critical to proper lubrication. Always
change filters regularly.
Use filters meeting John Deere performance
specification.
LUBRICANT STORAGE
This machine can operate at top efficiency only if clean
lubricants are used.
Use clean containers to handle all lubricants. Store
them in an area protected from dust, moisture, and
other contamination. Store drums on their sides.
SERIAL NUMBER LOCATIONS
When working on machines or components that are
covered by warranty, it is IMPORTANT that you include
the tractor identification number and
the component
serial numbers on the warranty claim form.
The location of tractor identification number and
component serial numbers are shown below.
TRACTOR IDENTIFICATION
NUMBER
ENGINE SERIAL NUMBER
HYDROSTATIC TRANSMISSION
SERIAL NUMBER
M99839
P.I.N.
Number
M99840
Engine ID
Number
20 HP Engine
M99841
Engine ID
Number
25 HP Engine
M99842
Transaxle
ID Number
To Next Page
Loading...
Need help?
General
