МТ-700 fleet tracking system 8
Package contents
Table 1
Voice call set(microphone and dynamic)
Device configuration
Device configuration and mounting should be conducted by trained specialists. The specialists should
conduct a training session on the installation of supplementary onboard electric equipment and a safety
protection guide on installation and service work, as shown in chapters 3 and 4.
This manual is written for a tracker; the most relevant software 19.X
Power source recommendations
The tracker is constructed for vehicles with the onboard voltage of 12/24 VDC. The
Internal overvoltage protection system will protect the device from voltage spikes up to 400 ms
and 200 VDC. Also, the internal overvoltage protection system can provide temporary work
from 60 VDC in; which may occur with the vehicles’ power lines in the event of an emergency.
If the input voltage exceeds the permitted threshold (chapter - Specification)
then the device will operate in the emergency mode. In the event that
exceeding voltage causes a malfunction it will not be covered by the
manufacturer.
In the event that the voltage is below 8,5 V, the device will enter shutdown mode in order to
protect its battery.
To Next Page
Loading...