SCULPFUN S10 - Step 2: Assemble X Beam and Front Beam

Step 2 Assemble X beam set and front beam
1
1
2
F
ront
B
eam
3
3
4
4
5
5
Motherboard
tripod
Tripod
Assembly steps：
1、Push the X beam assembly into the U-shaped frame, paying
attention to the direction of white logo !
2、Required components: tripod*1, motherboard tripod, front frame
beam, Step3 screw pack, T-shaped hexagonal wrench.
3、Assemble the tripod, main board tripod, and front frame beam
according to the right figure, install them in the order of step 12345,
and tighten the screws 1/3/4/5 in the order.
1 3 4 5
M5*18
M5*30
M5*8
M5*18