Need help?Do you have a question about the SCULPFUN S10 and is the answer not in the manual?
Explains the focal length and how to achieve optimal focus for engraving using measurement tools.
Details the procedure for adjusting the X and Y axis belt tension using screws and eccentric nuts.
General| Laser Power | 10W |
|---|---|
| Engraving Accuracy | 0.01mm |
| Data Transmission Method | USB |
| Y axis | 400mm |
| Laser Type | Diode Laser |
| Cooling System | Air Cooling |
| Focus Adjustment | Manual |
| Engraving Area | 400mm x 400mm |
| Focusing Method | Fixed Focus |
| Material Compatibility | Wood, Acrylic, Leather, Plastic, Bamboo, Paper, Rubber |
| Laser Protective Cover | Included |
| Operating Software | LaserGRBL |
| Supported File Formats | NC, BMP, JPG, PNG, DXF |
| Input Voltage | 100V-240V |
| Output Voltage | 24V |
| Engraving Speed | 10, 000mm/min |
| Dimensions | 570mm |
To Next Page
