Need help?Do you have a question about the SCULPFUN S9 and is the answer not in the manual?
General| Laser Power | 5.5W |
|---|---|
| Laser Wavelength | 455nm |
| Control Software | LaserGRBL, LightBurn |
| Input Format | NC, BMP, JPG, PNG, DXF |
| Data Transmission Method | USB |
| Engraving Speed | 10000mm/min |
| Laser Type | Diode Laser |
| Laser Protective Cover | Yes |
| Engraving Accuracy | 0.01mm |
| Cooling System | Air Cooling |
| Engraving Area | 410mm x 420mm |
| Material Compatibility | Wood, Plastic, Paper |
| Cutting Material | Wood, acrylic, leather, fabric |
| Power Supply | 12V 5A |
To Next Page
