SCULPFUN S9 - Step 1 Assemble the back, left and right beams; Assembly Notes and Screw Identification

Step 1 Assemble the back, left and right beams
1
1
2
4
3
3
4
2
Back Beam
Back Beam
Left Beam
Right Beam
Note：
1、Find the required tool and screw model before starting assembly: T-
shaped hexagon wrench,Step1 Screw bag, left/right/back frame beams,
tripod*2.
2、Notice label position! There is label paper on the beam, and the label
is placed in the position as shown on the left.
3、When assembling, ensure that the edges of the beam and the tripod
are neatly parallel and tight.
4、The picture on the left is the frame after Step1 is assembled.
Back Beam
Left Beam
Right Beam
1 2 3 4
M5*18
M5*30
M5*18
M5*8
Notice label !