PAGE
SAFETY INSTRUCTIONS
Maintenance operations must be carried out by persons possessing:
• the necessary electrical accreditation,
• knowledge of the equipment in question.
Some maintenance operations must be carried out by SDCEM technicians, who can also
provide you with assistance in assembly and adjustment of your installations. Please contact
SDCEM Services for all queries (contact details on the last page of this Instruction Book).
Electrical
accreditation :
Recognition of a person’s
ability to safely carry out
the tasks assigned to him/
her.
The accreditation
category specifies its
scope and limits
04
NTI010hA
INTRODUCTION
Safety and recommended tools
Operating mechanism
type MR41E
The installation concerned by the operation must be de-energised prior to operation.
Electrocution, burn, explosion, finger squeezing, cut-offs (handling, operations, etc.) hazards are
present at each operation.
Only qualified persons, complying with all safety regulations, are accredited to perform such
operations.
DANGER: Electrocution, burn and explosion hazards
Safety and operation instructions, personal protective equipment, tools
and signalling
Refer to local regulations and legislation.
RECOMMENDED TOOLS (Not supplied by SDCEM)
Adjustable spanner (600 long)
Spirit level
ENGLISH
To Next Page
Loading...