__________________ Quickwash
Plus
If the results are not within an acceptable correlation band then changes to the
Quickwash programs are
necessary
:
If the QuickWash result is too high:-
a.) Reduce washing time by 50% in wash cycle
Re-test and compare results to see if correlation is now achieved:
b.) Set the number of wash cycles to zero
If the QuickWash result is too low:-
a.) Increase the number of rinse dry cycles.
Successful correlation depends on the quality of the fabric and the standard
deviation of test procedure.
Correlation is not always possible against alternative drying methods:-
Tumble Dry - is always possible
Flat Dry - possible but operator dependent
Line Dry - NOT possible
To Next Page
Loading...