What to do if SDMO ST 2.36H Water Pump engine cuts out?
If the engine of your SDMO Water Pump cuts out, it could be due to blocked ventilation inlets. Clean the air inlet and outlet guards. Another possibility is that the oil cut-out has been triggered. In this case, check for any leaks and top up the oil level.
Why SDMO ST 2.36H Water Pump volume is low?
If you're experiencing low pump volume with your SDMO Water Pump, it could be due to several factors: 1. Air entering at the suction side: Check the path on the suction side. 2. Loss of engine power: Have the engine checked. 3. Damage to the mechanical seal: Have the seal replaced. 4. Suction side is too high: Lower the operating height. 5. Pipe is too long or kinked: Shorten or straighten out the pipe. 6. Liquid is leaking in the ducts: Seal the leak. 7. Turbine is clogged: Remove and clean it. 8. Turbine is worn: Have the pump checked.
What to do if SDMO Water Pump has automatic priming fault?
If you're experiencing an automatic priming fault with your SDMO Water Pump, here are a few things to check: * Ensure that air isn't entering at the suction side by checking the path on the suction side. * Make sure there's enough water in the pump body; fill it correctly. * Verify that the drain plug is properly tightened. * If these steps don't resolve the issue, the engine might not be rotating correctly, and you should have it checked. * Air could be entering through the mechanical seal, in which case you should have the seal replaced.
Step-by-step guide for starting the pump unit, including priming and initial checks.
Details on operating the pump, managing speed, and the correct procedure for switching the unit off.
Explains the oil cut-out feature designed to prevent engine damage due to low oil levels.
Identifies probable causes like low fuel or clogged air filter and provides remedial actions.
Lists reasons for engine shutdown, such as blocked inlets or oil cut-out, with solutions.
Addresses issues causing low volume, like air leaks or high suction side, and offers remedies.
Provides detailed technical specifications for different pump models, including engine type, power, and dimensions.
Confirms product conformity to EC Directives, listing manufacturer details and equipment types.
General| Model | ST 2.36H |
|---|---|
| Type | Water Pump |
| Pump Type | Centrifugal |
| Maximum Flow Rate | 36 m³/h |
| Maximum Head | 26 m |
| Suction Lift | 8 m |
| Engine | Honda GX160 |
| Fuel Type | Petrol |
| Inlet Diameter | 2" |
| Outlet Diameter | 2" |
To Next Page
