3 4
Using the display
Start to ride the bike
Error codes
1. Long press power button to turn on/off.
Note: the display will turn off automatically after 5 minutes of inactivity.
2.Assist level switch：Short press 、 buttons to switch pedal assist level. There are
0-6 PAS levels , When PAS level is empty, it means there is no pedal assist power
output which is PAS off state.
3. Information switch：In a power-on state, short press M button to switch in cycles
among TRIP, ODO and RANGE: TRIP/AVG -> ODO/MAX -> RANGE/AVG.
4. Light control function：To change light state manually under auto light function, long
press .
The auto light function is disabled, once the light on/off is operated manually.
Shutdown and turn on the display again, to activate the auto light function.
5. Speed info indication：The display provides speed info indication. Under standard
condition, the basic interface displays real-time speed, and switchable indication of
average speed AVG and maximum speed MAX.
6. Walk assist function：When speed is below 6 km/h, long press and hold button
to enter walk assist mode. Motor outputs power according to the set speed and
controls the actual walk speed, display shows the walk assist icon and the real-time
speed while PAS level shows empty. Release button or any other button to exit
walk assist mode, the motor will be turned off, and the display gets back to the basic
interface.
1. Turn on the battery, turn on the display and confirm it is nothing unusual, confirm
battery is full.
2. Engage first or higher gear, start to pedal a few times to get pedal assist, then
engage the throttle.
3. How the throttle works: The throttle is located on the right side of the handlebar. The
rider can use it with a twist of the throttle grip to propel the bike forward without
pedaling. To engage the throttle while riding, slowly and carefully rotate it toward
yourself. The more you twist, the more powerfully the motor will propel the bike
forward. Once you release the throttle or apply the brakes, the throttle will no longer
propel the bike forward. Always keep one hand on the brake lever and be prepared
to squeeze the lever to disengage the throttle if needed, or turn off the bike to
prevent accidentally engaging the throttle.
NOTICE: Throttle and motor use may not be allowed in all areas. It is your responsibility
to know and follow local ebike regulations, rules, and traffic laws where you ride.
If the bike detects a fault, an error code will be shown on the display.
Contact support@sdream.bike for additional information.
To Next Page
Loading...