12
Show Hidden Settings
Hides all settings above this point of the manual in the programmer, so in other words the programmer will skip over
the other settings, so if you scroll left using the < key, none of the above will appear. If all above settings are not
appearing then this setting must be NO so change this setting to YES to make all settings appear in the
programmer.
Recommended to just leave this set to YES unless you need to access the RET-ADV/LOAD settings many times.
When set to NO this will speed up access to RET-ADV/LOAD.
Values Lock
Extra protection against another person unknowingly pushing buttons on the system.
Press the plus key + to turn ON Values Lock, then most values cannot be changed.
Some however, are still able to be changed in event of a system problem or
emergency situation.
5 Unlockables are:
1. ON BACK BATT COIL “B” ON(OFF)-allows you to turn back ON the B coil pack in case of poor engine
performance on one coilpack, if it was set to cutoff coilpack B when on Battery power.
2. AUDIO CTRL.
3. BATTERY TEST.
4. RUNUP.
5. IGNITION OFF.
In all other windows, no settings can be changed.
To Next Page
Loading...