38
SDS Card Logger
The EM-6 introduces an external data logging module which connects to the primary ECU via the
supplied audio cable. This uses a 32Gb card (supplied), and is the maximum sized card that can be
used. This allows you to continuously log all ECU data and view it using SDSdash software on a
Windows device. SDSdash also allows you to view and print your ECU values.
Mounting can be either in the panel using 6-32 screws through the face or on the lower flange of the
panel using #8 screws through the provided flange. The upper cover plate may be reversed for additional
space near the panel surface if required.
Electrical connections are Red to +12V and Black to Ground. Breaker/Fuse with 2 amps. Included 1/8”
male-male audio cable plugs into the rear of the Logger and the other end plugs into the SDS gold ECU,
if dual ECU, then plug into the Primary (top) ecu.
To Next Page
Loading...
