Sea-doo GTI 2003 User Manual

75
Lubrication
Use SEA-DOO synthetic grease or
equivalent and lubricate PTO flywheel.
Proceed as follows:
Remove seat to expose engine com-
partment.
Remove vent tube support (if so
equipped).
PTO Flywheel
Remove the fasteners and pull out PTO
flywheel guard.
GTI, GTI LE AND GTI LE RFI MODELS
1. Flywheel guard
2. Wing nuts
TYPICAL — OTHER MODELS
1. Flywheel guard
2. Fasteners
Using a grease gun, carefully lubricate
PTO flywheel at grease fitting until
PTO flywheel boot begins to expand.
CAUTION: Immediately stop lubri-
cating as soon as PTO flywheel boot
begins to expand to prevent damage
or slipping.
1. PTO flywheel
2. Grease fitting
3. PTO flywheel boot
Reinstall and secure PTO flywheel guard.
Anticorrosion Protection
Throttle/Choke Cables
Lubricate the throttle and choke cables
(if so equipped) with BOMBARDIER
LUBE lubricant or equivalent.
Electrical Connections
As necessary, apply anticorrosion prod-
uct such as dielectric grease on battery
posts and all exposed cable connectors.

WARNING
Only perform procedures as de-
tailed in this guide. It is recom-
mended that the assistance of an
authorized SEA-DOO dealer be
periodically obtained on other
components/systems not covered
in this guide. Unless otherwise
specified, engine must not be run-
ning and the safety lanyard must
be removed from its post for all
maintenance procedures. Compo-
nents inside engine compartment
may be hot. Never use jet pump
components or side vanes to lift
the watercraft.
F06I04Y
2
1
F01I0AY
2
1
F01I0BZ
2
1
3
smo2003-001a.book Page 75 Monday, July 22, 2002 11:50 AM

Sea-doo GTI 2003 Specifications

General

Model	GTI
Year	2003
Manufacturer	Sea-Doo
Category	Boat
Displacement	718 cc
Horsepower	85 hp
Oil Capacity	3.2 quarts
Seating Capacity	3
Rider Capacity	3
Storage Capacity	7.7 gallons
Width	47 inches