Sea-doo Spark Series User Manual

118
Sea-Doo dealer to have any damaged
part repaired or replaced.
WWAARRNNIINNGG
TThhee tteetthheerr ccoorrdd mmuusstt aallwwaayyss bbee
rreemmoovveedd ffrroomm tthhee eennggiinnee ccuutt--ooffff
sswwiittcchh pprriioorr ttoo iinnssppeeccttiinngg tthhee iinn--
ttaakkee ggrraattee..
NNOOTTEE::
There is a reinforcement plate on LH
side of hull to maintain symmetry so
the hydrodynamics of PWC is not
affected.
1. Water intake
2. Heat exchanger
3. Reinforcement plate
SSaaccrriiffiicciiaall AAnnooddee
SSaaccrriiffiicciiaall AAnnooddee IInnssppeeccttiioonn
Check for wear. If worn more than
half, see an authorized Sea-Doo deal-
er for anode replacement.
1. Sacrificial anode location
SSaaccrriiffiicciiaall AAnnooddee RReemmoovvaall
Unscrew sacrificial anode retaining
nut and remove anode.
SSaaccrriiffiicciiaall AAnnooddee IInnssttaallllaattiioonn
Installation is the reverse of the re-
moval procedure.
TTiigghhtteenniinngg TToorrqquuee
9 ± 1 Nm (80 ± 9 lbf-in)
FFuusseess
FFuussee IInnssppeeccttiioonn
If an electrical problem occurs, check
the fuses. If a fuse is burnt, replace by
one of the same rating.
TTYYPPIICCAALL
1. Fuse
2. Check if melted
3. Ampere rating
MAINTENANCE PROCEDURES

Sea-doo Spark Series Specifications

General

Displacement	899 cc
Hull Material	Polytec
Model	Spark, Spark Trixx
Engine Type	Rotax 900 ACE
Horsepower	60 hp / 90 hp
Fuel Type	Gasoline
Fuel Capacity	7.9 US gal (30 L)
Seating Capacity	2 or 3
Length	120 inches (305 cm)
Width	46 in (117 cm)