Sea-doo Spark Series User Manual

SAFETY INFORMATION 51
WWhhaatt ttoo DDoo AAfftteerr LLaauunncchhiinngg
tthhee WWaatteerrccrraafftt
Check the items listed in the following
table after launching the watercraft
and before going for a ride.
WWAARRNNIINNGG
EEnnggiinnee sshhoouulldd bbee ooffff aanndd tthhee tteetthh--
eerr ccoorrdd ccaapp sshhoouulldd aallwwaayyss bbee rree--
mmoovveedd ffrroomm tthhee eennggiinnee ccuutt--ooffff
sswwiittcchh pprriioorr ttoo vveerriiffyyiinngg aannyy ooff tthhee
ffoolllloowwiinngg ppooiinnttss.. OOnnllyy ssttaarrtt wwaatteerr--
ccrraafftt oonnccee aallll iitteemmss hhaavvee bbeeeenn
cchheecckkeedd aanndd ooppeerraattee pprrooppeerrllyy..
NNOOTTEE:: Before starting the engine
and taking off, it is recommended to
shake vertically the rear of the water-
craft to shake away any sand that may
have accumulated near the propulsion
and reverse systems.
Check the items listed in the following
table before launching the watercraft.
ITEM OPERATION
Information Center Check
operation.
Intelligent Brake
and Reverse
System (iBR)
Check
operation.
Variable Trim
System (VTS)
Check
operation.
IInnffoorrmmaattiioonn CCeenntteerr ((GGaauuggee))
1. Press START/STOP button and in-
stall tether cord on the engine cut--
off switch.
2. As the information center cycles
through its self-test function, en-
sure all indications come on.
WWAARRNNIINNGG
AAllwwaayyss aattttaacchh tthhee tteetthheerr ccoorrdd cclliipp
ttoo yyoouurr PPFFDD oorr ttoo tthhee wwrriisstt ((wwrriisstt
ssttrraapp rreeqquuiirreedd))..
iiBBRR SSyysstteemm
NNOOTTIICCEE
EEnnssuurree tthheerree iiss ssuuffffiicciieenntt ssppaaccee
aahheeaadd aanndd bbeehhiinndd wwaatteerrccrraafftt ttoo
ssaaffeellyy ccaarrrryy oouutt tthhee iiBBRR ssyysstteemm
tteesstt ttoo aavvooiidd aa ccoolllliissiioonn.. WWaatteerr--
ccrraafftt wwiillll mmoovvee dduurriinngg tteesstt..
1. Remove the moorings lines secur-
ing the watercraft to the dock.
2. Start the engine and ensure the
watercraft does not move.
3. On the left handlebar, depress the
iBR lever completely in, the water-
craft should move slowly
backwards.
PRE-RIDE INSPECTION

Sea-doo Spark Series Specifications

General

Displacement	899 cc
Hull Material	Polytec
Model	Spark, Spark Trixx
Engine Type	Rotax 900 ACE
Horsepower	60 hp / 90 hp
Fuel Type	Gasoline
Fuel Capacity	7.9 US gal (30 L)
Seating Capacity	2 or 3
Length	120 inches (305 cm)
Width	46 in (117 cm)