Sistemi elettronici
di Aperture Porte e Cancelli
Sistemi elettronici
di Aperture Porte e Cancelli
SEA S.r.l.
Zona industriale 64020 S.ATTO Teramo - (ITALY)
Tel. 0861 588341 r.a. Fax 0861 588344
www.seateam.com
seacom@seateam.com
ARM
FITTING AND CONNECTION INSTRUCTIONS
DECLARATION OF CONFORMITY
SEA declares under its responsibility that the products
ARM
meets the essential requisites provided for by the following European Directive and following changes:
89/392/CEE (Machine Directive)
89/336/CEE (Electromagnetic Compatibility Directive)
73/23/CEE (Low Tension Directive)
SAFETY PRECAUTIONS:
All electrical work should conform to current regulations. A 16 A 0,030 A differential switch must be incorporated into the source of
the operators main electrical supply and the entire system properly earth bonded. Always run mains carrying cables in separate
ducts to low voltage control cables to prevent mains interference.
INTENDED USE:
ARM operator has been designed to be used only for the automation of swing gates.
SPARE PARTS:
To obtain spare parts contact:
SEA S.r.l. - Zona Ind.le S.Atto, 64020 S. Nicolò a Tordino - Teramo - ITALIA
SAFETY AND ENVIRONMENTAL COMPATIBILITY:
Don’t waste product packing materials and/or circuits.
When being transported this product must be properly packaged and handled with care.
MAINTENANCE AND OUT OF SERVICE:
The decommission and maintenance of ARM must only be carried out by specialised and authorised personnel.
NOTE: THE MANUFACTURER CAN NOT BE DEEMED RESPONSIBLE FOR ANY DAMAGE OR INJURY CAUSED BY
IMPROPER USE OF THIS PRODUCT.
SEA reserves the right to do changes or variations that may be necessary to its products with no obligation to notice.
RISK EXAMINATION
The points pointed by arrows in Fig. 18 are potentially dangerous.
The installer must take a close risk examination to prevent
crushing, conveying, cutting, grappling, trapping so to guarantee
a safe installation for people, things and animals
(
).
Re. Laws in force in the country where the installation has been
made
Fig. 18
ENGLISH
REV 05 - 10/2007
To Previous Page
Loading...
