Do you have a question about the SEA LIBRA HALF TANK and is the answer not in the manual?
Brand | SEA |
---|---|
Model | LIBRA HALF TANK |
Category | Gate Opener |
Language | English |
General rules and precautions for safe operation of the gate operator system.
Instructions to reduce the risk of injury or death during gate operation and maintenance.
Tasks for cleaning, checking parts, and inspecting connections when the gate operator is powered off.
Tasks for checking safety devices and accessories after the gate operator is powered on.
Conditions and requirements for installing a gate operator on gates and enclosures.
Instructions for placing controls away from moving parts and ensuring visibility of the gate area.
Requirements for minimum two independent means of entrapment protection for gate operators.
Mandates for monitoring sensors and installer responsibility for identifying entrapment risks.
Definitions and classifications for vehicular gate operators based on installation location and use.
Table detailing entrapment protection types (A, B1, B2, C, D) for different gate operator categories.
Warnings about gate use for vehicles only and importance of warning signs for pedestrians.
Technical specs for MINI, HALF, FULL TANK operators including power, stroke, and pressure.
Technical specifications for HALF TANK BRUSHLESS 36V operators.
Diagram and list of components required for standard gate operator installation.
Diagrams showing dimensions and considerations for inward opening gate installation.
Diagram showing installation on masonry pillars with a recess and relevant dimensions.
Preliminary notes on adjusting by-pass valves for opening and closing pressure.
Diagrams showing how to adjust grey (opening) and yellow (closing) by-pass valves.
Annual checks and lubrication procedures for gate operator maintenance.
Requirement to replace hydraulic oil every four years for operator upkeep.
Guidance on performing risk examinations to ensure safe installation and operation.