SEA MINI TANK User Manual

Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
®
SEA S.p.A.
Zona industriale 64020 S.ATTO Teramo - (ITALY)
Tel. +39 (0)861 588341 r.a. Fax +39 (0)861 588344
www.seateam.com
seacom@seateam.com
Italiano
English
Français
Español
Rev.01 - 06/201567411840
ENCODER LINEARE
LINEAR ENCODER
ENCODEUR LINÉAIRE
ENCODER LINEAL
Half Tank 270/390
Mini Tank

SEA MINI TANK Specifications

General

Brand	SEA
Model	MINI TANK
Category	Gate Opener
Language	English

Summary

Positioning of the Front Fixation

Important Note on Front Fixation

Avoid welding the front fixation to the rod, as welding residues could damage the rod's chrome plating.

Encoder Mounting Procedures

Ball Joint and Platelet Mounting

Instructions for mounting the ball joint and the mounting plate for the encoder.

Critical Assembly Warning

Caution against rotating the encoder rod during tie rod nut assembly to prevent malfunctions.

Encoder Installation for Existing Systems

Procedure for installing the encoder on existing systems, including drilling and control unit replacement.

Ball Joint Adjustment and Assembly Variations

Left and Right Assembly Adjustments

Details on left and right assembly adjustments for Half Tank and Mini Tank.

Final Encoder Installation Steps

Connector Fixing

Secure the connector to the rod with a clamp to prevent cable cutting during cover installation.

Protection Cover Mounting

Ensure the antivibration plastic frame is inserted before mounting the rod cover extrusion.

Cable Routing and Identification

Guidance on routing encoder cables and identifying wire connections.