SeaDoo Bombardier GTX 4-TEC - Set-Up and Battery Installation; Battery Preparation and Installation; Battery Cable Connection

SET-UP 4–TECSCModels
SET-UP
Battery Preparation
1
2
3
F18H1F6
Unscrew the battery bracket [
[[
[1]
]]
].
Using strap [
[[
[2]
]]
], lift the battery [
[[
[3]
]]
] out of the
watercraft.

WARNING
Do not charge the battery while installed in
the watercraft.
N
NN
NO
OO
OT
TT
TE
EE
E:
::
: Refer to last year Bombardier Sea-Doo
Shop Manual for the activation of a new battery.
Battery Installation
Install the battery in the battery support in the
engine compartment.
Secure the RED positive cable to the battery
positive post with:
- 1 hexagonal bolt from section no. 1 of predelivery
kit.
- 1 flat washer from section no. 1 of predelivery kit.
- 1 nut from section no. 1 of predelivery kit.
Secure the BLACK negative cable to the battery
negative post with:
- 1 hexagonal bolt from section no. 1 of predelivery
kit.
- 1 flat washer from section no. 1 of predelivery kit.
- 1 nut from section no. 1 of predelivery kit.

WARNING
Always connect the battery cables exactly in this
specific order. Connect RED positive cable first,
then the BLACK negative ground cable.
Secure the battery with:
- Bracket (previously removed).
- 2 flat washers (previously removed).
- 2 nuts (previously removed).
Apply dielectric grease (P/N 293 550 004) on
battery posts.
Cover battery positive post with rubber boot.
Remove the plastic red cap from the battery
vent elbow.
4 / 15 2004-1 Predelivery