SeaDoo Fish Pro User Manual

Polytec Surface
Care and Repair
Hull and Deck
Technical Service Procedures
IMPORTANT
BRP strongly recommends providing a copy of this
document to your local body shop before it performs
any repairs on a Polytec hull or deck.
Version Date: September 30, 2019
2 1 9 1 0 1 0 2 9

SeaDoo Fish Pro Specifications

General

Horsepower	170 hp
Seating Capacity	3
Type	Personal Watercraft
Engine	Rotax 1630 ACE
Fuel Type	Gasoline

Summary

CARE AND PRODUCTS

SPECIAL CARE OF POLYTEC SURFACES

Fuel Spillage

Aggressive Liquids and Solvents

Heat Gun

Flame Treatment

PRODUCTS SAFE FOR USE ON POLYTEC SURFACES

PRODUCTS TO BE USED WITH CAUTION ON POLYTEC SURFACES

Cautionary Notes for Product Use

PRODUCTS PROHIBITED FROM USE ON POLYTEC SURFACES

Prohibited Cleaning Agents

NEVER use cleaners with acetone, alcohol, ammonia, chlorinated solvents, mineral spirits, paint thinners, or petroleum products.

REPAIR PROCEDURES

Plastic Welding

Plastic Welding Requirements

Details essential tools, materials like welding rods, and purchase locations for plastic welding.

Plastic Welding Procedure

Preparation and Heating

Set tool temperature to 300°C (572°F), install nozzle, and prepare surfaces for welding.

Surface Preparation

Clean repair area, remove matting if needed, and sand the inside surface for adhesion.

Welding Process

Groove, heat, and apply welding rod in layers to fill the groove, ensuring proper melt-mixing.