148
MMOONNIITTOORRIINNGG SSYYSSTTEEMM
A system monitors the electronic com-
ponents of the EMS (engine manage-
ment system) iBR, and other
components of the electrical system.
When a fault occurs, it sends visual
messages through the information
center and/or audible signals through
a beeper to inform you of a particular
condition.
A fault code may also be recorded.
When a minor or transient fault oc-
curs, the fault message and beeper
will cease automatically if the condi-
tion that caused the fault does not ex-
ist anymore.
Releasing the throttle and letting the
engine return to idle speed may allow
normal operation to come back. If this
does not work, try removing and rein-
stalling the tether cord on the engine
cut-off switch.
The electronic system will react differ-
ently depending on the fault type. In
severe failure, the engine may not be
allowed to be started. In other cases,
the engine will operate in limp home
mode (reduced speed).
When a fault occurs, please refer to
the
US EPA Emission-Related War-
ranty
contained herein for information
about warranty claims.
FFaauulltt CCooddeess
When a fault occurs, a numerical fault
code may be recorded depending on
the fault type and system.
These fault codes are used by author-
ized Sea-Doo dealers for
troubleshooting the watercraft sys-
tems when comparing them to a fault
list.
Fault codes can be viewed in the infor-
mation center multifunction display
however, this function is only available
if a fault is still active.
If there is an active fault code, it may
be viewed by the operator on the mul-
tifunction display. The operator may
then choose to call his authorized
Sea-Doo dealer to pass on the fault
code. The dealer will then advise the
operator on the steps to take to solve
the problem, or to stop using the
watercraft and to bring it in to the deal-
er for repairs.
DDiissppllaayyiinngg FFaauulltt CCooddeess
Select CCOODDEESS. If a fault code has oc-
curred during your riding cycle, a CO-
DES menu will be available in the
settings menu. Press OK to see the
list of faults.
NNOOTTEE::
During normal riding conditions some
fault codes may occur. Before con-
tacting your local dealer, remove the
key, make sure to wait 2 minutes until
the electrical system shut down, then
press start to wake up the electrical
system. This will ensure occurred fault
to disappear and only the active codes
will remain ON in the CODES menu.
IInnddiiccaattoorr LLiigghhttss aanndd MMeessssaaggee DDiissppllaayy IInnffoorrmmaattiioonn
The indicator lights (pilot lamps) and messages displayed in the information cen-
ter will inform you of a particular condition or if an anomaly occurs.
For information on usual indicator lights, refer to appropriate digital display.
To Next Page
Loading...
