Need help?Do you have a question about the Seagate BARRACUDA ST8000DM004 and is the answer not in the manual?
Covers DC power requirements, consumption, and conducted noise levels.
Specifies the non-operating and operating ambient temperature ranges.
Information on how to determine drive warranty status and details on data loss.
Explains potential data loss during power interruptions and prevention methods.
Details the information transferred by the Identify Device command after power-up.
Explains how this command controls drive features like write cache and transfer modes.
Describes S.M.A.R.T. commands for drive failure prediction and diagnostics.
General| Type | HDD |
|---|---|
| HDD size | 3.5 \ |
| Hot-swap | - |
| HDD speed | 5400 RPM |
| Interface | Serial ATA III |
| HDD capacity | 8000 GB |
| Component for | Server/workstation |
| Storage drive buffer size | 256 MB |
| HDD sustained transfer rate | 220 MiB/s |
| Storage temperature (T-T) | -40 - 70 °C |
| Operating temperature (T-T) | 0 - 60 °C |
| Operating voltage | 5 / 12 V |
| Power consumption (idle) | 4.5 W |
| Power consumption (standby) | 0.8 W |
| Power consumption (typical) | 6.8 W |
| Harmonized System (HS) code | 84717050 |
Weight and Dimensions| Depth | 146.99 mm |
|---|---|
| Width | 101.85 mm |
| Height | 26.11 mm |
| Weight | 630 g |
To Next Page