Seakeeper 1 - Page 27

INSTALLATION
MANUAL
Product:
Document #:
Rev:
Page:
SEAKEEPER 1
90519
1
26 of 29
Section 4: INSTALLATION REQUIREMENTS
4.2 TOOLS REQUIRED FOR INSTALLATION
Table 2 outlines the tools and equipment required for the Seakeeper 1 installation:
Table 2: Tools and Equipment Required for Seakeeper 1 Installation
Item
Description
Use
1 Hoist, Forklift, or Crane Unpacking and lifting Seakeeper 1 into position
2
Transfer Punch Kit
Locate foundation hole penetrations
3 Drill / Drill Press Bolt hole penetrations
4
Threaded Insert Installation Kit
Tap and install threaded inserts (M14x2 1.5xDIA)
5 Marine Sealant Lower snubbing washer installation
6
Flexible Extendable Magnet, McMaster
P/N: 3838A42 or similar
Lowering foundation bolts into place
7
½” Drive Torque Wrench
Foundation Bolts (115 ft/lbs [15 N-m])
8 12-18” Extension, ½” Drive Foundation Bolts
9
22mm Socket
Foundation Bolts
10 Utility knife Scoring cable jackets
11
Wire cutter
DC Power Cables
12 Wire stripper DC Power Cables
13
Greenlee K05-Synchro Crimp Tool or
Equivalent
12VDC High Current Input Cables, 2 AWG
Ground Cable, 4AWG
14 Heat gun For conductor 1, 2, 6 heat shrink
15 Fish tape Cable pulls
16 Hole saw Thru-hull fittings
17
¼” (7mm) Nut Driver / Flat Head
Screwdriver
Hose clamps
• Note: Additional tools could be required for the installation of customer-supplied
components.