Need help?Do you have a question about the SEAL 62 Pro S and is the answer not in the manual?
Describes high-quality lamination, panel mounting, and decal application processes.
Mentions key parameters for controlling the lamination process: speed, pressure, tension, and temperature.
Explains what the manual covers, including installation, operation, and maintenance.
Lists the content and scope of each chapter within the manual.
Details the warranty terms, conditions, and duration for the machine.
Information on machine disposal and environmental considerations according to WEEE directive.
Covers essential safety features and operating instructions to prevent hazards.
Explains the different warning levels and symbols used within the manual.
Describes specific warning labels found on the machine itself for hazard identification.
Describes the machine's capabilities, functions, and general operation.
Lists and illustrates the main components and parts of the machine.
Details the fundamental mechanism by which the machine operates to laminate materials.
Information found on the machine's identification plate, including model and power rating.
Covers the width, height, and depth of the unit in both metric and imperial units.
Defines the types, widths, and diameters of materials that can be processed by the machine.
Outlines power requirements, process speeds, roller temperature limits, and noise levels.
Step-by-step guide for safely removing the machine from its packaging.
Guidance on relocating the machine to its final position and ensuring it is level.
Recommendations for safely moving the machine over distances or rough surfaces.
Introduces the primary controls and indicators found on the machine.
Detailed description of buttons, LEDs, and indicators on the control panel.
Instructions for setting and monitoring the roller temperature using the heater control.
Explains emergency stops, nip setting, foot switch, and tension controls.
Clarifies what different flashing LEDs signify and potential causes.
Describes standard operation, including speed control and roller direction.
Details how to use slow mode for setup and fine adjustments, with safety considerations.
Instructions for installing and using the auto-grip shaft system for holding film rolls.
Specific steps for handling films that have a release liner during loading.
Comprehensive instructions for loading various film types and orientations onto shafts.
Instructions for cleaning the machine's exterior surfaces to maintain performance.
Specific methods for cleaning the machine's rollers to prevent residue buildup.
Routine inspections to ensure proper machine function and longevity.
Checking and adjusting the auto-grip shaft mechanisms for correct operation.
Diagnosing and fixing wrinkles caused by excessive roller pressure.
Diagnosing and fixing wrinkles caused by insufficient roller pressure.
Addressing wrinkles related to low unwind tension on the film.
Troubleshooting problems caused by misaligned rollers, leading to uneven results.
Resolving issues where material rolls jump or feed unevenly during operation.
Guidance on how to contact support for technical assistance and problem resolution.
Explains the purpose and operation of the splitter bar for film processing.
Guidance on adjusting tension for optimal unwinding and smooth processing.
How to adjust pressure for thin images and panels for best results.
Preparing the machine with films for processing, for single or double-sided applications.
Steps for webbing when only the upper part of the machine is used.
Instructions for webbing both sections of the machine for various processes.
Specific webbing methods for roll-to-roll processes.
Step-by-step guide for affixing images or decals onto boards.
How to apply mounting film to boards as a substrate for mounting images.
Applying a protective laminate over a mounted image.
Process for laminating only one side of an image.
Encapsulating images using both sides of laminating films.
How to apply decals, similar to double-sided lamination.
Instructions for safely removing finished work and films from the machine.
Details about the manufacturer and the specific model of the machine.
Lists the standards the machine adheres to for safety and EMC.
Information for reaching technical support regarding the machine.
Information for reaching customer service for general inquiries.
Addresses for Seal/ACCO Brands in different regions.
To Next Page
General
