Sealey LS370H.V2 - 11. Attaching the Stand

11. ATTACHING THE STAND
NOTE: Stand not included
 WARNING! Make sure the splitter is unplugged before mounting it to the stand (g.24).
 WARNING! Make sure you have assistance when assembling the splitter stand.
11.1. Remove front stand and wheels from log splitter (g.25).
11.2. Attach the wheels from the log splitter to the stand. Attach the two uprights (g.26.A.B) to the log splitter.
11.3. The axles on the log splitter have to go through the hole in the tops of the posts (g.27) Some adjustment may be required when
attaching the legs to the splitter.
11.4. Assemble parts C, D and E (g.26) after attaching legs (g.26.A.B) to log splitter. There will be two different length bars for part D,
select the bar labelled for your log splitter.
11.5. Join the rest of the stand and the log splitter together. This step require at least two people.
NOTE: When assembling the frame you will be supplied with two different spacer bars use the one that is labelled for your splitter.
g.24
g.25
A
B
C
D
E
Wheel
Axle
g.26
g.27
Original Language Version
© Jack Sealey Limited
LS370H.V2 LS520H.V2 Issue 2 (3) 02/10/19