Sealey PC2950.V5 - Troubleshooting Guide; 6.5 Storage; 6.5.1 Store in a Location Where the Washer will Not be Subject to Freezing Conditions; 6.5.2 Make Sure that the Pressure Washer Has Been Drained of Water and Remove the Hoses

7. TROUBLESHOOTING GUIDE
PROBLEM CAUSE REMEDY
Motor will not start or stops during Loose or disconnected plug. Check plug connections / Reconnect plug
operation.
Tripped pressure washer thermal switch. Allow to cool and restart unit.
Power blast trigger not operating properly. Return to Service Agent
Circuit breaker trips or fuse blown Circuit overload. Check that power supply is correctly rated. Disconnect
in fuse box. other loads from circuit.
Extension lead too long or wire size Use proper lead as recommended in manual.
too small.
Nozzle partially blocked causing Clean nozzle.
excessive pressure.
Water or oil leaking from bottom of A small amount of leakage is normal. If leakage becomes excessive contact service agent.
pump.
Trigger will not move. Safety catch engaged. Release safety catch.
Unit will not stop when trigger is Auto stop system inoperative. Contact service agent.
released.
Motor running but pump not Water not turned on or partially on. Open water tap.
reaching maximum pressure or
has irregular pressure. Unit has been stored in freezing Thaw out unit completely including hose, gun and lance.
temperatures.
Water inlet filter clogged. Clean filter.
Kink in supply hose. Straighten hose.
Air in pump. Run washer with gun open and lance removed until
a steady stream of water emerges.
Suction or discharge valves worn out. Contact Service Agent.
 WARNING! Prevent water from penetrating the vents of the pressure washer to minimise the risk of damage to the machine and to
reduce risk of shock to the operator.
6.5 Storage.
6.5.1 Store in a location where the washer will not be subject to freezing conditions.
6.5.2 Make sure that the pressure washer has been drained of water and remove the hoses.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
sales@sealey.co.uk
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
email
Original Language Version
PC2950.V5 Issue: 2 - 01/06/11
Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to
www.sealey.co.uk, email sales@sealey.co.uk or phone 01284 757500.