Main Menu
1) VW/AUDI
►2) OBDII/EOBD
3) Oil Service
4) System Setup
7) Press the Y button. A sequence of messages showing the
OBDII/EOBD protocols will be observed on the display until the
vehicle protocol is detected.
If the scan tool fails to communicate with the vehicle’s ECU
(Engine Control Unit), a “LINK ERROR!” message shows
up on the display.
Verify that the ignition is ON;
Check if the scan tool’s OBD II connector is securely
connected to the vehicle’s DLC;
Verify that the vehicle is OBDII/EOBD compliant;
Turn the ignition off and wait for about 10 seconds. Turn the
ignition back to on and repeat the procedure from step 5.
If the “LINK ERROR” message does not go away, then there
might be problems for the scan tool to communicate with the
vehicle. Contact your local distributor or the Sealey’s
customer service department for assistance.
8) After the vehicle protocol is displayed on the screen, press any key or
wait about 2 seconds for the OBDII/EOBD DIAG. menu to come up.
9) Use the UP/DOWN scroll buttons to select Read Codes from the
menu and press the Y button.
To Next Page
Loading...