Seamax PowerMax Series - Adjusting the Speed; Battery Indicator; Maintenance; General Maintenance Procedures

10
ADJUSTING THE SPEED
 The motor is equipped with a stepless
speed controller. Motor stops at Mark
ZERO. Rotate the handle clockwise for
stepless forward speeds. Turn the handle
couterclosewise for backward speeds.
BATTERY INDICATOR
 The battery indicator displays the realtime
battery level. Recharge the battery when
its power level is decreased down to 20%.
MAINTENANCE
 You must disconnect the battery before maintenance.
 Always thoroughly rinse your electric outboard motor with fresh water after every use. Only rinse the areas
that have been in contact with salt water, avoid getting the top cover wet as this may damage the circuitry
inside.
 Check behind the propeller after each day for weeds, fishing line or other debris that may get wrapped
behind the propeller.
 Lubricate all the pivot points with a non-aerosol lubricant. Never use an aerosol lubricant as many types
contain harmful propellants that causes damage to various parts of your electric motor.
 Check tightness of the battery lead connections.
 Visually check condition of main battery cables.
 Inspect for loose or corroded wiring connections.
 Clean terminals with a wire brush and replace any frayed wires. Lack of maintenance may cause excessive
heat and loss of power.
 Inspect for tightness of all nuts, bolts and screws.
 Recharge batteries after each use. Follow the battery manufacturer’s recommendations for battery
maintenance.
 Be sure to choose a well ventilated and dry location when storing the motor for long period. Never leave the
motor outside, as this may cause damaged to the magnet of the driving unit. During freezing temperatures,
when your electric motor is not being used, it should be stored in an area where it will not freeze.