Sears CRAFTSMAN 944.602212 User Manual (English)

Questions and Answers:

J
Jay PettyAug 17, 2025
How to fix a Sears CRAFTSMAN 944.602212 that is hard to start?
- Y
  ybergerAug 17, 2025
  If your Sears Lawn Mower is hard to start, several factors could be the cause. It might be due to a dirty air filter (clean or replace it), a bad spark plug (replace it), or a weak or dead battery (recharge or replace the battery). Other potential causes include a dirty fuel filter (replace it), stale or dirty fuel (drain the tank and refill with fresh gasoline), or loose or damaged wiring (check all wiring). If these steps don't resolve the issue, the carburetor may be out of adjustment, or the engine valves may need adjustment.
J
Johnny FosterAug 19, 2025
What to do if Sears CRAFTSMAN 944.602212 engine will not turn over?
- H
  Heidi ChapmanAug 20, 2025
  If your Sears Lawn Mower engine won't turn over, make sure the clutch/brake pedal is fully depressed. Check that the attachment clutch is disengaged. A weak or dead battery can also prevent the engine from turning over, so recharge or replace the battery. Inspect the fuse and replace it if it's blown. Clean any corrosion from the battery terminals. Also, check all wiring for any loose or damaged connections. A faulty ignition switch, solenoid, or starter could also be the culprit; check and replace these components as needed.
A
Ashley BishopAug 22, 2025
Why does Sears CRAFTSMAN 944.602212 Lawn Mower engine backfire when turning off?
- M
  Michael TerryAug 22, 2025
  Your Sears Lawn Mower engine might backfire when turning it off if the engine throttle control isn't set at the 'SLOW' position for 30 seconds before stopping the engine. Move the throttle control to the 'SLOW' position and allow it to idle for 30 seconds before stopping the engine.
P
Patricia HamiltonAug 31, 2025
Why does my Sears CRAFTSMAN 944.602212 engine click but will not start?
- T
  Terri GrimesAug 31, 2025
  If your Sears Lawn Mower engine clicks but doesn't start, the issue could be a weak or dead battery; try recharging or replacing it. Corroded battery terminals can also cause this problem, so clean them thoroughly. Inspect all wiring for looseness or damage. Additionally, a faulty solenoid or starter might be the reason; check and replace these components if necessary.
J
Janet NelsonSep 2, 2025
What causes excessive vibration in Sears CRAFTSMAN 944.602212 Lawn Mower?
- R
  rebecca55Sep 2, 2025
  Excessive vibration in your Sears Lawn Mower could be due to a worn, bent, or loose blade; replace the blade and tighten the blade bolt. A bent blade mandrel can also cause vibration, so replace it if necessary. Check for any loose or damaged parts and tighten or replace them accordingly.
A
Andrea WardSep 5, 2025
Why is my Sears Lawn Mower leaving an uneven cut?
- L
  laurenhansonSep 5, 2025
  An uneven cut from your Sears Lawn Mower may be due to a worn, bent, or loose blade; replace the blade and tighten the blade bolt. Ensure the mower deck is level. Buildup of grass, leaves, and trash under the mower can also cause an uneven cut, so clean the underside of the mower housing. A bent blade mandrel can also be the reason; replace it if needed. Check for clogged mower deck vent holes from buildup of grass, leaves, and trash around mandrels, and clean around mandrels to open vent holes.
M
mackenzie65Sep 8, 2025
What to do if Sears CRAFTSMAN 944.602212 blades will not rotate?
- K
  Karen JordanSep 8, 2025
  If the blades on your Sears Lawn Mower won't rotate, start by checking for any obstruction in the clutch mechanism and remove it. A worn or damaged mower drive belt can also cause this issue, so replace the mower drive belt. Additionally, a frozen idler pulley or a frozen blade mandrel could be the problem; replace these components if necessary.
R
Ricky HerreraSep 12, 2025
Why are the headlights not working on my Sears CRAFTSMAN 944.602212 Lawn Mower?
- D
  Dana HopkinsSep 12, 2025
  If the headlights on your Sears Lawn Mower aren't working, first check if the switch is turned 'ON'. If not, turn it 'ON.' If the switch is on, the bulbs or lamps may be burned out, so replace them. A faulty light switch could also be the problem; check and replace it if necessary. Inspect the wiring and connections for any looseness or damage. Finally, check the fuse and replace it if it's blown.

Sears CRAFTSMAN 944.602212 Specifications

General

Engine Brand	Briggs & Stratton
Engine Type	4-cycle
Engine Displacement	190cc
Cutting Width	22 inches
Drive System	Self-propelled
Deck Material	Steel
Oil Capacity	20 oz
Fuel Tank Capacity	1.6 quarts
Wheel Size	8 inches (front), 11 inches (rear)

Summary

SAFETY RULES

GENERAL OPERATION

Guidelines for safe and proper operation of the cutting machine.

SLOPE OPERATION

Precautions and instructions for operating the tractor on slopes to prevent accidents.

CHILDREN

Safety measures to prevent tragic accidents involving children.

SERVICE

Safety precautions to follow during maintenance and repair of the equipment.

PRODUCT SPECIFICATIONS

Technical details including capacity, oil type, speed, pressure, and battery specifications.

WARRANTY

Details of the limited warranty coverage for the tractor and battery.

UNASSEMBLED PARTS

UNASSEMBLED PARTS LIST

Visual guide and list of parts that require assembly before operation.

ASSEMBLY

TOOLS REQUIRED FOR ASSEMBLY

List of tools necessary for assembling the tractor components.

TO REMOVE TRACTOR FROM CARTON

Instructions for safely unpacking the tractor from its shipping carton.

ATTACH STEERING WHEEL

Step-by-step guide for assembling the steering wheel and related components.

CONNECT BATTERY

Procedure for safely connecting the tractor's battery, including important precautions.

ASSEMBLY CONTINUED

CHECK TIRE PRESSURE

Ensuring tires are properly inflated for optimal cutting performance and safety.

CHECK DECK LEVELNESS

Procedure for leveling the mower deck for best cutting results.

CHECK BRAKE SYSTEM

Verifying the proper adjustment and operation of the tractor's brake system.

OPERATION

SYMBOL IDENTIFICATION

Explanation of various symbols used on the product and in the manual.

OPERATION CONTINUED

KNOW YOUR TRACTOR

Familiarization with tractor controls, their locations, and functions.

OPERATION CONTINUED

HOW TO USE YOUR TRACTOR

Detailed instructions on operating key tractor functions like parking brake, throttle, and gear shifting.

TO ADJUST MOWER CUTTING HEIGHT

Procedure for setting the desired cutting height of the mower deck.

OPERATION CONTINUED

BEFORE STARTING THE ENGINE

Essential checks and procedures to follow before starting the tractor's engine.

ADD GASOLINE

Instructions and precautions for adding fuel to the tractor's tank.

OPERATION CONTINUED

MOWING TIPS

Advice on proper mowing techniques for optimal results and efficiency.

MULCHING MOWING TIPS

Specific recommendations for effective mulching with the mower.

CUSTOMER RESPONSIBILITIES

MAINTENANCE SCHEDULE

A schedule outlining regular maintenance tasks and their recommended intervals.

LUBRICATION CHART

Diagram and guide for lubricating various parts of the tractor.

CUSTOMER RESPONSIBILITIES CONTINUED

TRACTOR SAFETY

General safety rules and responsibilities for operating the tractor.

BRAKE OPERATION

Information and adjustments related to the tractor's braking system.

BLADE CARE

Guidelines for maintaining mower blades, including removal and sharpening.

BATTERY CARE

Instructions for maintaining the tractor's battery and terminals.

CUSTOMER RESPONSIBILITIES CONTINUED

ENGINE LUBRICATION

Details on selecting the correct oil and performing oil changes for the engine.

TO CHANGE ENGINE OIL

Step-by-step procedure for draining and refilling the engine oil.

CUSTOMER RESPONSIBILITIES CONTINUED

AIR FILTER MAINTENANCE

Procedures for cleaning and servicing the engine's air filter system.

IN-LINE FUEL FILTER REPLACEMENT

Instructions for replacing the fuel filter to ensure proper fuel flow.

SERVICE AND ADJUSTMENTS

TO REMOVE MOWER

Detailed steps for safely detaching the mower deck from the tractor.

TO INSTALL MOWER

Instructions for correctly mounting the mower deck onto the tractor.

SERVICE AND ADJUSTMENTS CONTINUED

TO LEVEL MOWER HOUSING

Procedure for adjusting the mower deck for optimal cutting height and balance.

SERVICE AND ADJUSTMENTS CONTINUED

TO ADJUST BRAKE

Instructions for adjusting the tractor's braking system for proper stopping distance.

SERVICE AND ADJUSTMENTS CONTINUED

TRANSAXLE GEAR SHIFT LEVER NEUTRAL ADJUSTMENT

Procedure to ensure the transaxle is in neutral when the gear shift lever is in the N position.

TO START ENGINE WITH A WEAK BATTERY

Guidance on safely jump-starting the tractor with a weak battery.

SERVICE AND ADJUSTMENTS CONTINUED

TO REPLACE HEADLIGHT BULB

Steps for replacing a burnt-out headlight bulb.

TO REMOVE HOOD AND GRILL ASSEMBLY

Procedure for removing the tractor's hood and grill assembly.

SERVICE AND ADJUSTMENTS CONTINUED

ENGINE ADJUSTMENTS

Instructions for adjusting throttle and choke controls for optimal engine performance.

STORAGE

TRACTOR STORAGE PREPARATION

Steps to prepare the tractor for long-term storage, including cleaning and lubrication.

ENGINE STORAGE

Procedures for preparing the engine, fuel system, and cylinders for storage.

TROUBLESHOOTING POINTS

TROUBLESHOOTING GUIDE

A table listing common problems, their causes, and recommended corrections.

SCHEMATIC

TRACTOR WIRING SCHEMATIC

Diagram illustrating the tractor's electrical wiring system.

ELECTRICAL REPAIR PARTS

ELECTRICAL SYSTEM PARTS

Diagram and list of electrical parts for the tractor.

CHASSIS AND ENCLOSURES REPAIR PARTS

CHASSIS AND ENCLOSURES PARTS

Diagram and list of chassis and enclosure parts for the tractor.

DRIVE SYSTEM REPAIR PARTS

DRIVE SYSTEM PARTS

Diagram and list of parts related to the tractor's drive system.

STEERING ASSEMBLY REPAIR PARTS

STEERING ASSEMBLY PARTS

Diagram and list of parts for the tractor's steering assembly.

SEAT ASSEMBLY REPAIR PARTS

SEAT ASSEMBLY PARTS

Diagram and list of parts for the tractor's seat assembly.

DECALS, WHEELS & TIRES REPAIR PARTS

DECALS, WHEELS & TIRES PARTS

Diagrams and lists for decals, wheels, and tires.

ENGINE REPAIR PARTS

ENGINE PARTS

Diagram of the engine and its associated parts.

MOWER DECK REPAIR PARTS

MOWER DECK PARTS

Diagram and list of parts for the mower deck assembly.

LIFT MECHANISM REPAIR PARTS

LIFT MECHANISM PARTS

Diagram and list of parts for the mower deck lift mechanism.

TRANSAXLE REPAIR PARTS

TRANSAXLE PARTS

Diagram and list of parts for the Peerless PMST Transaxle.

BRIGGS & STRATTON ENGINE REPAIR PARTS

BRIGGS & STRATTON ENGINE PARTS

Diagram showing parts for the Briggs & Stratton engine.

SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION

SLOPE MEASUREMENT GUIDE

Instructions on how to use a folded page to measure slope angles for safe operation.

Related product manuals

Sears CRAFTSMAN 944.602000

60 pages

Sears CRAFTSMAN 944.602131

52 pages

Sears CRAFTSMAN 944.602151

52 pages

Sears CRAFTSMAN 944.602900

60 pages

Sears CRAFTSMAN 944.605931

52 pages

Sears CRAFTSMAN 944.608340

52 pages

Sears Craftsman 944.601131

56 pages

Sears CRAFTSMAN 944.600892

56 pages

Sears CRAFTSMAN 944.604110

52 pages

Sears CRAFTSMAN 944.601080

52 pages

Sears CRAFTSMAN 944.601090

52 pages

Sears CRAFTSMAN 944.603050

60 pages

Sears CRAFTSMAN 944.602212 User Manual

Table of Contents

Questions and Answers:

Sears CRAFTSMAN 944.602212 Specifications

Summary

SAFETY RULES

GENERAL OPERATION

SLOPE OPERATION

CHILDREN

SERVICE

PRODUCT SPECIFICATIONS

PRODUCT SPECIFICATIONS

WARRANTY

UNASSEMBLED PARTS

UNASSEMBLED PARTS LIST

ASSEMBLY

TOOLS REQUIRED FOR ASSEMBLY

TO REMOVE TRACTOR FROM CARTON

ATTACH STEERING WHEEL

CONNECT BATTERY

ASSEMBLY CONTINUED

CHECK TIRE PRESSURE

CHECK DECK LEVELNESS

CHECK BRAKE SYSTEM

OPERATION

SYMBOL IDENTIFICATION

OPERATION CONTINUED

KNOW YOUR TRACTOR

OPERATION CONTINUED

HOW TO USE YOUR TRACTOR

TO ADJUST MOWER CUTTING HEIGHT

OPERATION CONTINUED

BEFORE STARTING THE ENGINE

ADD GASOLINE

OPERATION CONTINUED

MOWING TIPS

MULCHING MOWING TIPS

CUSTOMER RESPONSIBILITIES

MAINTENANCE SCHEDULE

LUBRICATION CHART

CUSTOMER RESPONSIBILITIES CONTINUED

TRACTOR SAFETY

BRAKE OPERATION

BLADE CARE

BATTERY CARE

CUSTOMER RESPONSIBILITIES CONTINUED

ENGINE LUBRICATION

TO CHANGE ENGINE OIL

CUSTOMER RESPONSIBILITIES CONTINUED

AIR FILTER MAINTENANCE

IN-LINE FUEL FILTER REPLACEMENT

SERVICE AND ADJUSTMENTS

TO REMOVE MOWER

TO INSTALL MOWER

SERVICE AND ADJUSTMENTS CONTINUED

TO LEVEL MOWER HOUSING

SERVICE AND ADJUSTMENTS CONTINUED

TO ADJUST BRAKE

SERVICE AND ADJUSTMENTS CONTINUED

TRANSAXLE GEAR SHIFT LEVER NEUTRAL ADJUSTMENT

TO START ENGINE WITH A WEAK BATTERY

SERVICE AND ADJUSTMENTS CONTINUED

TO REPLACE HEADLIGHT BULB

TO REMOVE HOOD AND GRILL ASSEMBLY

SERVICE AND ADJUSTMENTS CONTINUED

ENGINE ADJUSTMENTS

STORAGE

TRACTOR STORAGE PREPARATION

ENGINE STORAGE

TROUBLESHOOTING POINTS

TROUBLESHOOTING GUIDE

SCHEMATIC

TRACTOR WIRING SCHEMATIC

ELECTRICAL REPAIR PARTS

ELECTRICAL SYSTEM PARTS

CHASSIS AND ENCLOSURES REPAIR PARTS

CHASSIS AND ENCLOSURES PARTS

DRIVE SYSTEM REPAIR PARTS

DRIVE SYSTEM PARTS

STEERING ASSEMBLY REPAIR PARTS