9
2) Setting the mast using the A-frame
A frame comes with following
parts. It is powder coated so
make sure you don’t damage
the paint to prevent corro-
sion.
Slide the top part of the tube
into the bottom part of the
tube and secure it using the
pin. Make sure you tighten
the nuts all the way.
The aft support lines are
already attached to the top
of the A-frame. Use the
gennaker sheets for forward
support. Attach them to the
side rings on the top of the
A-frame.
Use composite shackle to
attach one of the blocks
Use Tack-line for the mast
hoist line. Run it trough the
thimble and tie the loose end
together.
To Next Page
Loading...
